Easylife EL5606 Instruction Manual

PANTONE 072 C
PANTONE 123 C
6. Attach 4 x plastic caps (E) by inserting them into the pre-drilled holes in each outer leg (see Fig D).
Fig D
7. Attach the head board (I) to the frame of the bed using 2 x bolts (J), align the holes in the head
board with the pre-drilled holes in the frame of the bed and secure in place with 2 x nuts (K) and
tighten with the spanner.
Please note the headboard bolts are a cup square bolt, when securing each nut tighten firmly so
the bolt sits flush with the headboard.

OPERATION

To operate the bed, hold the head board and the opposing handle on the frame and release the two
snap locks. Gently lower one side of the bed to the floor and then repeat for the other side. To close the
bed simply fold both sides and secure in place with the snap locks.

WARNING

• Please do not place hands near hinges when operating the bed
• Please be careful when opening and closing the bed as the side snap locks may
cause potential harm to the user
• The recommended weight load for this bed is 120kgs

TECHNICAL SPECIFICATION

Measurements: Open - L200xW80xH39cm (6ft 7inx2ft 7inx15in).
Folded - L80xW85xH39cm (2ft 7inx2ft 9inx15in).
Imported and distributed by Easylife Group Ltd, London NW1 0JP
Customer service: 0871 855 6100
For more innovative products from Easylife please visit:
www.easylifegroup.com
IN5606-1 © 2013 Easylife Group Ltd
Paper weight 60gsm
Maximum
user weight
120kg
Deluxe Folding Guest Bed
INSTRUCTION MANUAL
SINGULAR
QUALITY
IN THE
GUEST
ROOM
Model No. EL5606
Please read carefully before use and keep for future reference
Customer service: 0871 855 6100
For more innovative products from Easylife please visit:
www.easylifegroup.com