Summary of Contents for Packo Eco Cool Ice Builder
- Page 1 Torhoutsesteenweg 154 B-8210 ZEDELGEM Tel . + 32 50 25 06 10 Fax + 32 50 20 07 52 E-mail: inox@packo.com User Manual Packo Ice Builder (PIB) Ref. 168042 V 2.00 Eco Cool Ref. 168042...
-
Page 2: Table Of Contents
Table of contents ABOUT THIS MANUAL ..................... 3 SAFETY INSTRUCTIONS ....................4 EQUIPMENT OVERVIEW ..................6 ELECTRICAL CONTROL PANEL .................. 8 START-UP AND NORMAL USE ................12 3.1. PIB ......................12 ILLING 3.2...................... 13 OPERATION Manual Packo Ice Builders... -
Page 3: About This Manual
About this manual We, at PACKO INOX N.V., thank you for choosing one of our products and hope Introduction we may also count you as one of our satisfied customers. Therefore we strive to do everything possible to inform you and be of service as well as possible. -
Page 4: Safety Instructions
Service or maintenance works should only be carried out by trained personnel. Maintenance & fault finding Electricity Before doing the following, turn the main switch (located on the side of the electrical control cabinet) to 0 or OFF and lock it: Manual Packo Ice Builders... - Page 5 - Only use the PIB for its intended use which means the creation of ice General water. - The PIB is not suitable for cooling other liquids then ice water. - Do not put anything on the PIB. Manual Packo Ice Builders...
-
Page 6: Equipment Overview
1. Equipment overview The Packo Ice Builders (PIB) are compact and powerful units capable of storing cooling energy in ice form and afterwards releasing this energy by generating ice water for various cooling applications. Manual Packo Ice Builders... - Page 7 - Type B28*46 (flow rate = 40l/min) - Type B28*80 (flow rate = 60 l/min) - Type B28*126 (flow rate = 100 l/min) Type B28*126 is not possible with PIB-8 and PIB-13 Manual Packo Ice Builders...
-
Page 8: Electrical Control Panel
2. Electrical control panel Cooling unit 1 Cooling unit 2 Main Switch Manual Packo Ice Builders... - Page 9 On : when ThKa is closed and HP is closed and BP is closed and cooling is active 26H5 Lamp HP Compressor 2 On : when HP is closed and BP is closed and cooling is active (Model dependant) Manual Packo Ice Builders...
- Page 10 On : when ThKa is closed and HP is closed and BP is closed and cooling is active Ice water circuit - M: 45S1 Switch Ice water pump 1 Manual operation - 0: M-0-A Pump off - A: Automatic operation Manual Packo Ice Builders...
- Page 11 - A: Automatic operation Lamp (Model Thermal Safety ice Indicates when ice water pump 2 47H4, dependant) water pump 2 is overloaded. … Level control - M: Switch Level control Manual operation 55S1 - A: Automatic operation Manual Packo Ice Builders...
-
Page 12: Start-Up And Normal Use
3. Start-up and normal use 3.1. Filling PIB The Packo Ice Builder has to be filled with pure, clear water (drinking quality) up to 1cm above the top copper tube of the evaporator. The ice water reservoir may only be filled with water after the cooling circuit has been made vacuum and put under pressure. -
Page 13: Pib Operation
During a prolonged period without ice building (cooling units are not running), the cooling units can switch on and off for a short period. Always leave the ice accumulator under tension to ensure proper control of the ice capacity. Manual Packo Ice Builders...