Summary of Contents for Propox JTAGcable II
- Page 1 JTAGcable II In Circuit Emulator for Atmel AVR microcontrollers User’s Guide Many ideas one solution REV 1.0...
- Page 2 Introduction Thank you for buying our JTAGcable II emulator. We hope that the great power it offers will allow you to appreciate fully the virtues of debugging and programming in the system provided by Atmel microcontrollers. JTAGcable II constitutes a tool for programming, real-time emulation in the target circuit and debugging of processors of the AVR family of Atmel microprocessors equipped with a JTAG interface.
- Page 3 Supported devices Below is a list of devices supported by the emulator. As new devices appear, the list is going to be modified. The current list is always available in the AVRStudio program. ATmega128, ATmega128L, AT90CAN128 ATmega64, ATmega64L ATmega32, ATmega32L ATmega323, ATmega323L ATmega16, ATmega16L ATmega162, ATmega162L, ATmega162V...
- Page 4 1.8 and 6 V. The JTAGcable II can be supplied from an external source or directly from the target circuit. In the last case, the supply voltage should have a value between 4.5 and 5.5 V.
- Page 5 signals, the signal level converter buffers limit the input and output currents. Buffering has been applied on all signal lines of the emulator. The implementation of a signal level converter for output lines has been shown in the figure below. From uC ISP HEADER ZENER...
- Page 6 USB cable for connection of the emulator with a PC • CD with documentation and software Technical assistance In order to obtain technical assistance, please contact support@propox.com Please provide the following data: • Clock frequency and type of processor in the PC •...
Need help?
Do you have a question about the JTAGcable II and is the answer not in the manual?
Questions and answers