Advertisement

EN
All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon
Hobby, LLC. For up-to-date product literature, visit horizonhobby.com or towerhobbies.com and click on the support
tab for this product.
The following terms are used throughout the product literature to indicate various levels of potential harm when
operating this product:
WARNING: Procedures, which if not properly followed, create the probability of property damage, collateral
damage, and serious injury OR create a high probability of superfi cial injury.
CAUTION: Procedures, which if not properly followed, create the probability of physical property damage AND a
possibility of serious injury.
NOTICE: Procedures, which if not properly followed, create a possibility of physical property damage AND a little or
no possibility of injury.
WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before
operating. Failure to operate the product correctly can result in damage to the product, personal property and
cause serious injury.
This is a sophisticated hobby product. It must be operated with caution and common sense and requires some basic
mechanical ability. Failure to operate this Product in a safe and responsible manner could result in injury or damage to the
product or other property. This product is not intended for use by children without direct adult supervision. Do not use with
incompatible components or alter this product in any way outside of the instructions provided by Horizon Hobby, LLC. This
manual contains instructions for safety, operation and maintenance. It is essential to read and follow all the instructions and
warnings in the manual, prior to assembly, setup or use, in order to operate correctly and avoid damage or serious injury.
Age Recommendation: Not for children under 14 years. This is not a toy.
SAFETY PRECAUTIONS
As the user of this product, you are solely responsible for operating in a manner that does not endanger yourself and
others or result in damage to the product or property of others.
• Always ensure all batteries have been properly charged prior to using the model.
• Always check all servos and their connections prior to each run.
• Never operate your model near spectators, parking areas or any other area that could result in injury to people or
damage of property.
• Never operate your model during adverse weather conditions. Poor visibility can cause disorientation and loss of
control of your model.
• Never point the transmitter antenna directly toward the model. The radiation pattern from the tip of the antenna is
inherently low.
• If at any time during the operation of your model you observe any erratic or abnormal operation, immediately stop
operation of your model until the cause of the problem has been ascertained and corrected.
Instruction Manual // Bedienungsanleitung //
Manuel d'utilisation // Manuale di Istruzioni
AX4 2.4GHz Transmitter, AE6 ESC/Receiver
NOTICE
MEANING OF SPECIAL LANGUAGE
AXI31618, AXI31620

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AXI31618 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Axial AXI31618

  • Page 1 AXI31618, AXI31620 Instruction Manual // Bedienungsanleitung // Manuel d’utilisation // Manuale di Istruzioni AX4 2.4GHz Transmitter, AE6 ESC/Receiver NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit horizonhobby.com or towerhobbies.com and click on the support tab for this product.
  • Page 2: Table Of Contents

    Install the Transmitter Batteries ......... 5 IC Information..............8 Transmitter and Receiver Binding ........5 Compliance Information for the European Union ....8 Steering Trim (CH1) ............. 6 SPECIFICATIONS TRANSMITTER RECEIVER Model AXI31618 Model AXI31620 Power Output <100mW Frequency 2.4GHz FHSS Voltage 4.8–6V Voltage 6–7.4V...
  • Page 3: Transmitter Layout

    TRANSMITTER LAYOUT Use the diagram below to familiarize yourself with the different parts of your transmitter. The transmitter antenna is mounted internally and is located in the front portion of the transmitter. When you are driving your model, hold the transmitter so it is oriented as close to vertical as possible. Do not try to follow your model with the transmitter.
  • Page 4: Receiver Layout And Connections

    RECEIVER LAYOUT AND CONNECTIONS Use the diagrams to familiarize yourself with how to Antenna Exit connect the switch harness, servos (available separately), Brake ON/OFF LED and battery to the receiver. Backward LED NOTICE: Set your model on a stand so the wheels are Brake LED off the ground before powering on the radio control CH3 (Auxillary)
  • Page 5: Install The Transmitter Batteries

    INSTALL THE TRANSMITTER BATTERIES 1. Press the battery compartment latch and rotate the batter cover to open. 2. Install 4 AA alkaline batteries (or Ni-Cd or Ni-MH), verifying correct polarity. 3. Close the battery cover until it latches. CAUTION: NEVER remove the transmitter batteries while the vehicle is powered ON.
  • Page 6: Steering Trim (Ch1)

    STEERING TRIM (CH1) Steering neutral adjustments can be made by moving the steering trim knob to the left or right. When you install a servo, always check that the servo is in neutral. Adjust the servo horn position and linkage to both are parallel.
  • Page 7: Warranty And Service Contact Information

    www.horizonhobby.com, submit a Product Support Inquiry, Warranty Requirements — For Warranty consideration, or call the toll free telephone number referenced in the you must include your original sales receipt verifying the Warranty and Service Contact Information section to proof-of-purchase date. Provided warranty conditions have speak with a Product Support representative.
  • Page 8: Fcc Information

    Supplier’s Declaration of Conformity • Reorient or relocate the receiving antenna. AX4 2.4GHz Transmitter, AE6 ESC/Receiver (AXI31618) • Increase the separation between the equipment and This device complies with part 15 of the FCC receiver.
  • Page 9 | fl ickr.com/axialrc ©2019 Horizon Hobby, LLC. Axial, the Axial logo and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. All other trademarks, service marks and logos are property of their respective owners. Created 1/19...

This manual is also suitable for:

Axi31620

Table of Contents