Regulatory Information - Sony PCG-Z505GE Guía Del Usuario

Precaución: Para reducir el
riesgo de incendio, utilice
únicamente cable de línea de
telecomunicaciones nº 26
AWG o mayor.
Caution: To reduce the risk of
fire, use only No. 26 AWG or
larger telecommunication
line cord.
Attention : Afin de réduire les
risques d'incendie, n'utilisez
qu'un cordon de
communication N0. 26 AWG
ou plus gros.

Regulatory Information

If you have any questions about this product,
you can reach the Sony Customer Information
Service Center at 1-888-4SONYPC; or write to
the Sony Customer Information Service Center
at 12451 Gateway Blvd., Ft. Meyers, FL 33913,
or find Sony Customer Service on the Web at:
http://www.sony.com/pcsupport.
Declaration of Conformity
Trade Name:
Model No.:
Responsible
Party:
Address:
Telephone:
SONY
PCG-534D
Sony Electronics Inc.
1 Sony Drive
Park Ridge, NJ 07656
201-930-6972
This phone number is for FCC-related matters
only.
This device complies with Part 15 of the FCC
rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
❑
Reorient or relocate the receiving
antenna.
❑
Increase the separation between
the equipment and the receiver.
❑
Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
❑
Consult the dealer or an
experienced radio/TV technician
for help.
5