Operating Instructions - HAPRO Luxura X3 Owner's Manual

A B C
A : Start
In stand-alone mode: press 1X, the tanning time can now be set.
Standard is stand-alone time.
"Head fan +" for extending the tanning time.
"Head fan -" for shortening the tanning time.
Press once more to start the tanning unit.
NB.: When an external timer or coin operation is used the tanning unit
will start automaticall y .
C: Body fan +
1 Turning on the body fan.
E: Face
1 Turning the face tanner(s) or soft lamps on and off.
NB.: When during the tanning session the face tanner(s) cuts out,
the tanning unit will observe 4 minutes cooling time before the face
tanner(s) can be reactivated.
G: LED window
Display on the operating panel.
!
Caution: when using an external timer or coin operation set the stand-alone time in all cases to "zero".
D E F
- 9 -
Operation
G
B: Stop
Stopping the tanning unit.
Press stop 1X: pause position.
Press stop 2X: reset tanning time.
NB.: After each tanning session there is a standard (mandatory) after-
cooling interval of 3 minutes. During this 3-minute interval the unit
cannot be switched on.
D Body fan -
1 Disengagement of the body fan.
F: Hidden button
Read-out of the number of hours of operation (depress F button"
simultaneousl y with "body fan -)
NB.: the number of hours of operation is the value on the display
multiplied by 10.
Then press the "F button" to return to stand-alone mode.
Setting the stand-alone time:
The stand-alone time can be set by depressing the F and the body
fan+ button simultaneousl y (10 sec.). The body fan + and - buttons may
now be used to increase or reduce the stand-alone time.
The maximum setting for tanning time is 40 minutes.
NB.: Depressing F again after setting will confirm the stand-alone
time set.