CONTENT SAFETY INSTRUCTIONS LITHIUM BATTERY SAFETY PRECAUTION PARTS AND COMPONENTS INSTALLATION GUIDE 6- 7 OPERATION INSTRUCTIONS 8- 9 FILTER CARE AND REPLACEMENT FILTER CLEANING AND MAINTENANCE TROUBLE SHOOTING SPECIFICATION DEAR VALUED CUSTOMER, Thank you for your purchase of the Air Treatment Unit MODEL HK/HL. For your safety and to optimize the capabilities of this appliance, please read and retain this manual before operating the appliance;...
SAFETY INSTRUCTIONS Please read the following instructions before use. The appliance is designed for domestic usage and may only be operated in accordance with the following instructions. WARNING Do not expose the product to water and do not unplug the product with wet hands. Do not clean or spray the appliance with water, liquid, detergent, or any flammable liquids.
Do not push, lean against or exert excessive force on any part of the appliance. Do not stick sharp objects into any part of the appliance. 10. If the NCCO Reactor is not properly installed, the appliance would not operate. 11. Maintain good air circulation when using the appliance.
Page 5
protective circuit board so that the battery doses not work and causes over-heated, distort, smoke or burning. Use the compatible chargers in the recommended charging method to charge the battery. Do not short-circuit the positive and negative contacts. Do not demolish or assembly the appliance and the battery by yourself.
② ③ 3. Take out the HEPA Filter and remove the package. 4. Place the HEPA filter to the NCCO reactor to make it as filter set. 5. Install the filter set to the machine body. Press it down firmly.
Page 8
B) Hanging to the headrest. 1. Make sure power supply is disconnected before lifting up/move the appliance. 2. Use a spiral to loosen the screws of the 2 small covers on the bottom side of the appliance. Place the belt across the rectangular holes, then resume the covers to their original position and fasten the covers’...
: blue light would be shown. Tips for Filter installation When NCCO Reactor is installed improperly, machine will not work with a “DiDi” sound beeping. Solution: disconnect the machine from the electricity socket. Open the cover to take out all filters and re-install the filters.
Page 10
Protection scheme If the power supply is not stable, it may trigger the protection scheme that the appliance will stop operating. Please make sure correct adaptor is used. Memory function The appliance will remain the same operation status as last usage when there is power supplier again.
2. To maintain optimal performance, only use recommended filters. 3. Always disconnect appliance from the power supply before disassembling. 4. When the NCCO Reactor needs to be replaced, it is recommended to replace the HEPA Filter at the same time.
2. Replace HEPA Filter regularly to maintain the performance of the appliance. 3. Do not wipe or clean the HEPA Filter or NCCO Reactor with water. Cleaning Exterior Body Use dry and soft cloth to clean the appliance.
TROUBLE SHOOTING Problems Resolutions Check if the device has been plugged in. The appliance does not operate Start up the device. Appliance is “beeping” in sound Check if the Filters are installed correctly. and does not operate. Reinstall all Filters Check if the Filters are installed correctly.