Summary of Contents for GARDTECH GT30007
- Page 1 ELECTRIC LAWN MOWER INSTRUCTION MANUAL GT30007 32CM 868301A 1100W, 868301B 1300W ALWAYS READ THESE OPERATING INSTRUCTIONS PRIOR TO USE...
- Page 2 I- Contents Parts list Technical data Safety instructions Assembly instructions Operating II- Parts list Upper handle Lower handle Switch box Grass collection box Wheels Motor cover 7. Cable hook 8. Cable holder III- Technical data Voltage 230-240V~ 50Hz Power rating 1300W No load speed 3300/min...
- Page 3 Sound pressure level at the operator’s position: 83.3 dB (A), K=1.17 dB (A) Declared guaranteed sound power level: 96dB (A) The sound intensity level for operator may exceed 85dB(A) and ear protection measures are necessary Information: - The declared vibration total value has been measured in accordance with a standard test method and may be used for comparing one tool with another - The declared vibration total value may also be used in a preliminary assessment of exposure.
- Page 4 h) Use extreme caution when reversing or pulling the machine towards you. i) Stop the blade(s) if the machine has to be tilted for transportation when crossing surfaces other than grass, and when transporting the machine to and from the area to be used. j) Never operate the machine with defective guards or shields, or without safety devices, for example deflectors and/or grass collector, in place.
- Page 5 Operate the appliance only in daylight or in good artificial light. Avoid operating the appliance in wet grass, where feasible. Always be sure of your footing on slopes. Always work across the face of slopes, never up and down. Exercise extreme caution when reversing or pulling the appliance towards to you. Do not operate the appliance on excessively steep slopes.
- Page 6 Debris may be ejected from the discharge chute The tines will continue to rotate for a short while after the rake has been switched off. Do not pick up or carry the rake until the tines has stopped rotating This product is double insulated electrically Disconnect from mains power immediately if the power cord becomes damaged.
- Page 7 3) Put cable hook and fix the cable with cable holders(fig.1c) Fig.1c 4) Fit each wheels over the axles, put one washer firstly, then secure in place with the “R” pins and press the wheel covers into place.(fig. 1d) Fig.1d 5) Grass collection box assembly.
- Page 8 Fig.1f 6) Lift the flap and place the grass box over the lugs.(fig.1g) Fig.1g CUTTING HEIGHT ADJUSTMENT To obtain the desired cutting height, the front and rear axles are repositioned on the underside of the mower housing. Warning! Disconnect the mower from the power supply and ensure the blade has stopped coasting before adjusting the height.
- Page 9 Note: Make sure that both right and left wheels are located in the same cutting height adjustment position. 2. Cutting height positions (fig.2b) 1)30mm (lowest cutting height position) 2)45mm 3)60mm (highest cutting height position) Fig.2b VI-Operating Connect to power supply Warning! Before connecting to the mains supply, always check the switch is in off position.
- Page 10 Warning! Do not work towards the cable. Blade maintenance(fig.5) Regularly remove grass and dirt from the blade. At the beginning of the gardening season, carefully examine the condition of the blade. If the blade is very blunt, sharpen or replace the blade. If the blade is damaged or worn, fit a new blade.