Saxby Lighting Ikon Pro CCT Series Instruction Leaflet

Wiring
If not using the supplied plug then the product must
be wired to an IP67 (or higher rated) terminal block
(recommended terminal block ref 61515).
Kit Layout Diagram
Care and Cleaning
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could damage the finish.
To prolong the life and keep your outdoor lighting in good condition, it is recommended that periodically it is cleaned
using a soft cloth followed by the application of a light coating of oil, such as WD40.
Do not clean the units with a pressure washer.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Safety information
Live Voltages may be present in the transformer even when turned off or when completely disconnected.
For your safety, always switch off the supply before maintaining the system.
'The LED module of this luminaire is not replaceable, when the LED module reaches its end of life the whole
luminaire shall be replaced
www.saxbylighting.com
Having correctly identified the wiring from your existing
light fitting, connect to the approved outdoor rated
external terminal block in the following way:
Iss 3 27022018
Saxby Lighting. BH23 3PE
Instruction leaflet
Ikon Pro CCT Outdoor LED Kit
73347, 73348, 73349, 76615, 76616, 76617