Summary of Contents for Innoquest GoTow 36520
- Page 1 DRILL-POWERED TOW BAR USE A CORDLESS DRILL TO MOVE YOUR AIRPLANE Model #36520 DRILL-POWERED TOW BAR PRODUCT MANUAL Made In The USA...
- Page 3 INSTRUCTIONS IN ENGLISH | GOTOW DRILL-POWERED TOW BAR SAFETY: Warning: Keep fingers and hands away from the drive chain at all times when a drill is attached to the GoTow to avoid possible injury. Warning: Stepping off of the GoTow while your airplane is on a steep slope may cause the GoTow tire to start sliding since your weight provides the traction.
-
Page 4: Specifications
INSTRUCTIONS IN ENGLISH | GOTOW DRILL-POWERED TOW BAR SPECIFICATIONS: Drill Requirements: 18v or greater cordless drill with 1/2in (13mm) chuck capacity (drill not included with purchase) Typical Tow Speed: 12ft/min(4m/min) with drill on LOW 42ft/min(13m/min) with drill on HIGH Max User Weight: 270 lb (123 kg) Max Recommended 3600 lb (1636 kg) - Page 5 INSTRUCTIONS IN ENGLISH | GOTOW DRILL-POWERED TOW BAR GOTOW COMPONENTS: Handlebars for steering Cordless Drill (Not Included) Carry Handle Wheel Chock Storage Strap Attachment & Release Handle Lug Tubes for Airplane Attachment Tow Arm Flat-Free Drive Tire Transport Wheels Operator Platform Drive Head GoTow Drill-Powered Tow Bar Item #36520...
- Page 6 INSTRUCTIONS IN ENGLISH | GOTOW DRILL-POWERED TOW BAR ASSEMBLY: Before Starting Unpack and inspect components: Tools needed: Tow Arm, Operator Platform, Handle Bars. ½” Wrench, Tape Measure Drive Head, 5/16-18 x 7/8 Hex Bolts (10) Step 1 – Attach the operator platform Attach the operator platform to the drive head with (4) included 5/16-18 x 7/8 hex bolts (fully tighten).
- Page 7 INSTRUCTIONS IN ENGLISH | GOTOW DRILL-POWERED TOW BAR Step 4 – Prep for attachment to your airplane Use the ½” wrench to loosen the lug tube clamps and slide each to the full open position (leave loose for next steps). Step 5 –...
- Page 8 INSTRUCTIONS IN ENGLISH | GOTOW DRILL-POWERED TOW BAR Step 7 – Test lug tube positions Depress the thumb latch button and move the lug tubes to the open position. If you cannot remove the GoTow from the airplane in this open position, then readjust the position of each lug tube to provide enough clearance for removal in this open position.
- Page 9 INSTRUCTIONS IN ENGLISH | GOTOW DRILL-POWERED TOW BAR Attachment THUMB LATCH Attach to your airplane by holding both handles for alignment and then twist the attachment handle to lock it onto the lugs. Make sure the thumb latch has engaged so there is no chance it will accidentally come loose during use.
- Page 10 INSTRUCTIONS IN ENGLISH | GOTOW DRILL-POWERED TOW BAR Stow your chocks Lubrication Every month or as needed apply 2 pumps of grease to the grease fitting on the drive head as shown. Also from time to time apply a light coating of grease to the outside of the lug tubes and the diagonal slot on the tow arm.
-
Page 11: Warranty, Service, And Returns
A restocking fee (the greater of 15% of the purchase price or $35) will apply to any returns sent back to Innoquest for a refund. For a refund, the product must be in the original sealed packaging provided by Innoquest. If the unit was opened but is completely functional and returned in good condition as determined by Innoquest, a repackaging fee not to exceed $25 will be added to the restocking fee. - Page 12 Attach to airplane by adjusting lugs Adjust pivot angle so transport wheels are always 2-3 inches above the ground Always 2-3” ground 910 Hobe Road Woodstock, IL 60098 US 800-637-1623 | International +1-815-337-8555 sales@innoquestinc.com www.innoquestinc.com © 2019 Innoquest, Inc P/N 36640 Rev.0...
Need help?
Do you have a question about the GoTow 36520 and is the answer not in the manual?
Questions and answers