HIKOB GATEWAY H-GW103A Installation Manual

Hide thumbs Also See for GATEWAY H-GW103A:

Advertisement

This document may not be reproduced (even partially) or communicated
to 3rd parties without the written authorization of the company's General
Management. Copyright © HIKOB.

Installation Guide

INSTALL_GATEWAY-V5
2019/01 Edition
Related HIKOB products:
GATEWAY H-GW103A
GATEWAY H-GW103D-G
INJ PH-AC100A
INJ RH-AC100A
ARM RH-AC100A
ARM H-AC100A-ARM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GATEWAY H-GW103A and is the answer not in the manual?

Questions and answers

Summary of Contents for HIKOB GATEWAY H-GW103A

  • Page 1: Installation Guide

    Related HIKOB products: GATEWAY H-GW103A GATEWAY H-GW103D-G INJ PH-AC100A INJ RH-AC100A ARM RH-AC100A ARM H-AC100A-ARM This document may not be reproduced (even partially) or communicated to 3rd parties without the written authorization of the company’s General Management. Copyright © HIKOB.
  • Page 2: Table Of Contents

    Europe ......................... 4 1.3.2 USA ........................4 WEEE ......................... 5 Technical Support ..................... 5 General description ................... 6 HIKOB Wireless sensor network acquisition system ..........6 GATEWAY overview....................6 Technical information ..................8 Global ......................... 8 Radio .......................... 8 3.2.1 HIKOB network ....................
  • Page 3: Introduction

    Please read this guide before installing, using the product, or performing any maintenance operation. Failure to read, understand and follow herein instructions may result in personal injury. In no event shall HIKOB be held liable for any damages arising out of or related to misunderstanding instructions detailed in this manual.
  • Page 4: Compliance And Conformity

    2019/01 Edition 1.3 Compliance and conformity 1.3.1 Europe HIKOB SAS declares that the HIKOB GATEWAY LITE product is in accordance with stipulations of the RED 2014/53/UE, CEM 2014/30/UE and 2014/35/UE directives. 1.3.2 USA Information to user: This device complies with part 15 of the FCC Rules. Operation is subject...
  • Page 5: Weee

    1.5 Technical Support HIKOB SAS 55 chemin du Vieux Chêne 38240 MEYLAN FRANCE Phone: +33 4 28 29 54 50 support@hikob.com...
  • Page 6: General Description

    2 General description 2.1 HIKOB Wireless sensor network acquisition system The GATEWAY is one of the elements that constitutes the HIKOB wireless sensor radio network. This system is a set of wireless sensors doing multi-point distributed measures in various domains. These sensors radio transmit their acquired data to the GATEWAY, possibly via LION routers, depending on environment constraints for radio transmission.
  • Page 7 Installation Guide INSTALL_GATEWAY-V5 2019/01 Edition ingress of dust, the second number 5, identifies protection against the effects of spraying water. Should you decide to perform cleaning tasks on the GATEWAY, don’t perform high pressure cleaning, prefer wiping with a dry cloth, or with a neutral agent. Radio and GPS antennas are integrated into the envelope of the GATEWAY, which are delivered all assembled and ready to be fastened on a pole or a wall, please refer to the Installation section for details.
  • Page 8: Technical Information

    Range 30m to a buried sensor 3.2.2 Maintenance [13.553MHz – 13.567MHz] Frequency band Protocol Type of receiver Passive Usage Only for HIKOB maintenace 3.3 GPS Constellation GPS L1 Antenna type Active patch Antenna gain +25dB 3.4 Connections Number of connectors...
  • Page 9: Installation

    4 Installation 4.1 Overall Methodology Installing an HIKOB radio network requires a good topology analysis of your site to maximize radio transmission quality by optimizing positions and numbers of HIKOB nodes in the network. A preliminary study done with your vendor determines elements that will constitute your HIKOB radio network acquisition.
  • Page 10: Outdoor Deployment

    Some PoE are sold to be useable outdoor, some are sold with an extra IP66 enclosure, when choosing your equipment, pay attention to the 802.3af-2003 and 802.3af-2009 compatibility and to operating temperatures as well. HIKOB has some product references to advise, ask our vendors.
  • Page 11: Gateway Arm's Mounting Process

    2019/01 Edition Plug this set up connector to the female Ethernet connector on the back of the GATEWAY. 4.3.2 GATEWAY arm’s mounting process The GATEWAY is delivered ready to be installed. HIKOB highly recommends using RAM ® MOUNTS products that can be optionally purchased with your GATEWAY, ask your vendor.

Table of Contents