Do you have a question about the 6ES2 and is the answer not in the manual?
Questions and answers
Summary of Contents for SIOX 6ES2
Page 1
ES2 Ethernet/SIOX Gateway p 2 General Description ..............1 Block Diagram ................1 TELEFR RANG AB Versions ................... 1 Ethe ernet/SIOX X Gatewa ay ES2 Installation and Startup ............3 Gener ral Description Power Supply ................4 ...
Page 2
After power is applied to the unit, check the yellow Link LED, located on the left side The ES2 is a bus master that supplies current to the SIOX bus in the same way as, of the RJ-45 connector. It will be activated if there is a working connection to for instance, the K32 unit does.
Page 3
The third way to get in contact with the unit is more universal and will also - 63 in order to find the ES2 unit. Note that several other SIOX modules may appear make it possible to recover a module set at an unknown IP-address. To if a SIOX bus is connected to the ES2.
Page 4
ES2 unit is permanently removed. Otherwise another equipment occupying the same IP-address could possibly represent a security hazard. • ES2 address (1 - 63) on the SIOX bus for its virtual SIOX module, thru which these configurations are carried out. This address can not be used by any SIOX module connected to the SIOX bus.
Page 5
This bit is used for other purposes. a lower baud rate. Secondly, fewer SIOX modules can be connected to the bus. As a complement, the SIOX R30 Bus Expander unit can be used if a bus segment needs to be strengthened.
Page 6
= Second byte of Default Gateway address zero for normal conditions. However, if there are special 0-255 SIOX modules connected to the bus, i.e. modems or radio modules, extra timeout may be added to Parameter 18: (0000 Restart unit to effectuate change compensate for the delay in these units.
Page 7
ES2 Ethernet/SIOX Gateway p 13 Electrical Specifications = 20 ° Unit Power Supply Voltage V DC Power Supply Voltage V AC Power Supply Current (@24 VDC) Idle, no SIOX communication Normal operation SIOX bus shorted DI1-4 Input voltage V DC...
Need help?
Do you have a question about the 6ES2 and is the answer not in the manual?
Questions and answers