UEi COA1 Instruction Manual

Carbon monoxide detector adapter

Advertisement

Quick Links

Carbon Monoxide Detector Adapter
INSTRUCTION MANUAL
ENGLISH
REQUIRES Compatible mobile device and the
FREE downloadable App, "CoChecker"
www.ueitest.com • email: info@ueitest.com
WARNING
: The COA1 is an ambient CO detector and not intended for in-flue stream
uses, to be used as personal safety device or medical applications. Refer to IMPORTANT
SAFETY WARNINGS section for more details.
NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operations.
INFORMATION TO THE USER
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING
: Any changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
COA1
1-800-547-5740

FCC INFORMATION

COA1
Carbon Monoxide Adapter
LOW BAT

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the COA1 and is the answer not in the manual?

Questions and answers

Summary of Contents for UEi COA1

  • Page 1: Fcc Information

    1-800-547-5740 www.ueitest.com • email: info@ueitest.com WARNING : The COA1 is an ambient CO detector and not intended for in-flue stream uses, to be used as personal safety device or medical applications. Refer to IMPORTANT SAFETY WARNINGS section for more details.
  • Page 2: General Specifications

    Green ≤ 10 Orange ≤ 35 Red. CAUTION • The COA1 is designed for ambient testing only. DO NOT place the instrument in flue gas or warm air streams. • The COA1 is not designed for in-flue detection. Readings more than 999 ppm will damage the sensor in the COA1, even if readings continue above the 999ppm range.
  • Page 3: Battery Replacement

    (CR2032) battery. • Replace the battery cover. : 1 x CR2032 3V MADE IN KOREA : 1 x CR2032 3V MADE IN KOREA NOTE: The COA1 will disconnect from the device when battery levels are too low to display correct readings.
  • Page 4: Troubleshooting

    WARRANTY The COA1 is warranted to be free from defects in materials and workmanship for a period of one year from the date of purchase. If within the warranty period your instrument should become inoperative from such defects, the unit will be repaired or replaced at UEi’s option.

Table of Contents