Advertisement
Parameter Table
E.
Parameters display
~
~
~
Parameter is a multi-pattern control function. Every pattern can perform 8 steps of temperature control.
Via link pattern, 64 steps of temperature control can be performed.
Press MOD 4 times under SV/PV mode，sub-menu can be selected under the main menu as below:
：8 pattern selection：Total of 8 patterns for selection. It is also the first action pattern among
： Step selection ： Step 1~8. Temperature increase/decrease, temperature hold can be set in each
step.
~：Temperature setup：Set target temperature in each step.
Ex.： SV=50 PV=30 SV1=50 tr1=1 ts1=2
PV starts to increase to reach SV(increase speed is in inverse ratio to ramp time). After 1
~：Time of increase/decrease(Ramp)：Set time needed(minute) in order to reach the set
~：Time of holding(Soak)：Time of hold(minute) after ramp time.
Name of Parameters
Pattern NO.
Number of steps
Set Value
Ramp time
Soak time
Repeat time
Link pattern
Time signal step
Signal 1 ON time
Signal 1 OFF time
Time signal2 step
Signal2 ON time
Signal2 OFF time
the 8 patterns.
minute, SV reaches 50 and temperature begins holding for 2 minutes.
temperature.
Description of Parameters
Pattern selection
Steps needed to be performed
Temperature setup
Time increase/decrease(min)
Time of temperature holding(min)
Repeat time
Link pattern
Output signal step 1
Signal 1 ON time (min)
Signal 1 OFF time (min)
Output signal step 2
Signal 2 ON time (min)
Signal 2 OFF time (min)
13
Display range
Value
~
~
~
~
~
~
~8
~
~
~
~
~
~
1
8
0
0
0
0
0
r1
0
0
r1
0
0
Advertisement
