Advertisement
Table of Contents
Programming instructions for KF425
We suggest that the following procedures are carried out before cutting the
new key. Key blade requires cutting by your local locksmith.
The transponder programming procedure allows the new key to start the engine.
The original key used in this procedure must be a Master (black) key. When
performing the below procedure, ensure you give the pedals firm presses. Weak
presses may not register with the vehicle and the learning procedure will not work.
1.
Insert original working master key (black headed key) in to the ignition (leave in
Lock position).
2.
Press the accelerator pedal 5 times.
3.
Press the brake pedal 6 times.
4.
Remove the original key from the ignition and insert new key to be
programmed leaving it in the Lock position.
5.
Press accelerator pedal once.
6.
Wait a full 60 seconds.
7.
If performed correctly the security LED on the vehicle will turn off. Once turned
off the new transponder is programmed.
8.
Remove new key from the ignition.
If the new key is cut it will now be able to start the ignition. Do not test if the key
blank is not cut.
TRANSPONDER PROGRAMMING
Advertisement
Table of Contents
Related Manuals for Map KF425
Summary of Contents for Map KF425
- Page 1 Programming instructions for KF425 We suggest that the following procedures are carried out before cutting the new key. Key blade requires cutting by your local locksmith. TRANSPONDER PROGRAMMING The transponder programming procedure allows the new key to start the engine.
- Page 2 REMOTE PROGRAMMING The remote programming procedure allows you to lock and unlock vehicle with the buttons on the new key. The following procedure can be carried out using any cut key that starts the engine. 1. Sit in vehicle with driver’s door open & remove any keys from the vehicle’s ignition.
Need help?
Do you have a question about the KF425 and is the answer not in the manual?
Questions and answers