Connecting The Ipod - Toyota PT546-52121 Owner's Manual

About iPod software version
The iPod software versions that
can be used with this unit are as
follows (operations verified as of
March 011):
iPod (5th generation)
iPod classic
iPod classic 120 GB
iPod classic 160 GB
iPod nano (1st generation)
iPod nano (2nd generation)
iPod nano (3rd generation)
iPod nano (4th generation)
iPod nano (5th generation)
iPod nano (6th generation)
iPod touch (1st generation)
iPod touch (2nd generation)
iPod touch (3rd generation)
iPod touch (4th generation)
iPhone
iPhone 3G
iPhone 3GS
iPhone 4
Please note that no guarantee applies to iPod
*
operations and future updated versions of iPod
software.

Connecting the iPod

Connect the USB connector.
Connect the iPod as indicated
in the figure below using a USB
cable.
Push the Dock connector into the
ver. 1.3
Dock connector port until you
ver. 2.0
hear a click to connect firmly. If it
ver. 2.0.1
does not go in smoothly, it may be
ver. 2.0.4
upside down so do not force it in as
ver. 1.3.1
this may result in damage.
ver. 1.1.3
ver. 1.1.3
ver. 1.0.4
ver. 1.0.1
iPod with Dock connector port
ver. 1.0
iOS3.0
iOS3.0
*1
iOS3.1.1
iOS4.1
iOS3.1.2
Dock connector
iOS3.0
iOS3.0.1
iOS4.2
When connecting the iPod, remove
a headphone cable from the iPod.
When connecting the iPod, it is
recommended to use a separately
purchased car kit.
USB port
To the vehicle's
USB connector
*2
*1
It is recommended to use a USB cable which
satisfies USB 2.0 standards.
(Measurements should satisfy USB 2.0 standards)
*2
Connection location differs depending on the
vehicle.
As soon as the iPod is connected, its
power is automatically turned on.
While the iPod is connected to this
unit, the Apple logo (or
mark)) is displayed on the iPod.
• While the iPod is connected to
this unit, the iPod itself cannot be
turned on or off.
• You cannot use the iPod's remote
control at the same time.
• You may hear noise if you
disconnect during iPod playback.
(check
1