Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for ekwb EK-FC Terminal X
- Page 1 1st revision, Aug 9th 2017 EK-FC Terminal X USER GUIDE...
- Page 2 GENERAL INFORMATION: SERIAL VS PARALLEL Serial or successive flow: Parallel flow: Water starts flowing initially through first Water flows through all blocks simultane- block, continues to second block and ously. With such configuration each water ends up with the third block. Whole sys- block gets one third of all flow.
- Page 3 CHOOSING INLET AND OUTLET PORT It is of highest importance to use correct inlet and outlet port configuration. Not using the correct ports may result in water bypassing the water blocks instead of flowing through the water blocks. As a result the bypassed graphics card will overheat and may get damaged beyond repair! Do not use IN and OUT on the same No inlet...
- Page 4 Do not use IN and OUT on the same terminal hole! No inlet or outlet OPTIONAL * possible No inlet OPTIONAL * or outlet possible Serial Terminal Parallel Terminal / 4 /...
- Page 5 Semi-Parallel Terminal Semi-Parallel Terminal No inlet or No inlet or outlet possible outlet possible No inlet or No inlet or outlet possible outlet possible / 5 /...
- Page 6 AT TACHING THE EK-FC TERMINAL X Screw M4x28 DIN7984 OR 15x1mm gasket / 6 /...
- Page 7 Save the O-ring gaskets and M4 Screws (mentioned in the first paragraph) from the FC Single Terminal. 2. Install the gaskets (OR 15x1mm) in grooved slots on your new EK-FC Terminal X interconnect. Make sure the gaskets are installed correctly! Each water block or blank link requires two (2) gaskets! 3.
- Page 8 ATTACHING THE EK-FC TERMINAL BLANK PARALLEL Tighten the three (3) enclosed M4x25 DIN7984 screws to EK- Screw M4x25 DIN7984 FC Terminal BLANK Parallel us- ing Allen (hex) key 2.5mm. Make sure the small 15x1mm gas- OR 15x1mm kets are correctly in- gasket stalled! Pay attention placement...
- Page 9 ATTACHING THE EK-FC TERMINAL BLANK SERIAL Tighten the three (3) enclosed Screw M4x28 DIN7984 M4x28 DIN7984 screws to EK- FC Terminal BLANK Serial using Allen (hex) key 2.5mm. OR 15x1mm Make sure the small gasket 15x1mm gas- kets are correctly in- stalled! Pay attention placement make sure the are not...
- Page 10 ATTACHING THE EK-FC TERMINAL ANGLED OR 15x1mm gasket EK-FC Terminal Angled M4x10 DIN7984 M4x28 DIN7984 / 10 /...
- Page 11 ATTACHING THE EK-FC TERMINAL DIRECT OR 15x1mm gasket EK-FC Terminal Direct M4x28 DIN7984 / 11 /...
- Page 12 ATTACHING THE EK-FC TERMINAL ROTARY 90° OR 15x1mm gasket EK-FC Terminal Rotary 90° M4x8 DIN7984...
Need help?
Do you have a question about the EK-FC Terminal X and is the answer not in the manual?
Questions and answers