Operating Functions - Dimplex DHCER20HC Instruction Manual

OPERATING FUNCTIONS

Setting the desired temperature:
1) The temperature shown on the numerical display on the heater is the current temperature.
2) To adjust the desired heating temperature:
a. Ensure the heater is in heating mode. Either the
the control unit display. If it isn't press the
b. Press the up or down temperature buttons to change the desired/set temperature:
• When setting the desired heat temperature, the numerical display on the heater will flash with the
desired temperature (adjust with appropriate up and down arrows). After 5 seconds without input,
the numerical display will stop flashing and it will lock in this desired temperature selection. The
heater will now heat up to this temperature. The numerical display will have reverted to showing
the current room temperature (rather than the desired heating temperature).
• You can select between 15ºC and 35ºC
If both the timer and set temperatures are set, the numerical display will alternate every 30
seconds between showing the remaining time on the timer and the current room temperature.
Setting the timer:
The unit has a runback timer: while the unit is on, set the number of hours for the unit to operate
until switching off automatically
a. On the control panel on the unit, press the
up
b. On the remote control, press the up or down temperature buttons
to select the number of hours.
• When setting the desired number of hours for the timer, the control panel "h" signal will light
up next to the numerical display, which will flash with the desired number of hours (adjust with
appropriate up and down arrows). To confirm this timer setting, either press the
or leave the numerical display to flash for 5 seconds. After this, the timer duration is set. The
numerical display will have reverted to showing the current room temperature.
• You can select between 1 and 12 hours
If both the timer and set temperatures are set, the numerical display will alternate every 30
seconds between showing the remaining time on the timer and the current room temperature.
On the unit:
On the remote control:
or down arrow buttons to select the number of hours.
on the remote control or the unit.
or
button and then the
or should be shown on
button
– 7 –