Download Print this page

Penn Elcom FT01-Q-DTC Product Data Sheet

Thermostatic fantray

PRODUCT DATA SHEET

Product Description

1U Rack Mountable Digital Thermostatically Controlled Quiet Fan Tray unit, for use in 19" equipment

racks. It is designed be fitted at the top of the rack to move hot air up through the rack as required.

 Continuous temperature monitoring

 Set & forget fan control

 Fan run LED indicator

 Over temperature alarm

 Temperature Sensor Input Socket

 Plug-in PTC sensor 1m lead

 Low Noise (22.5 dBA)

 12V DC Operation - 500mA

 3 x 9 Bladed Swiss 120mm Fans

 220 CFM / 378m³/h

 Japan made Fluid Bearings

 Temperature Sensor Input Socket

 DC in/out sockets

 1A world wide universal PSU supplied

 Black Powder Coated Steel Construction

 Dimensions (OD) 44.5 x 483 x 222mm

 Weight 1.4kgs

FT01-Q-DTC

THERMOSTATIC FANTRAY

Table of Contents

Do you have a question about the FT01-Q-DTC and is the answer not in the manual?

Page 1 FT01-Q-DTC PRODUCT DATA SHEET THERMOSTATIC FANTRAY Product Description 1U Rack Mountable Digital Thermostatically Controlled Quiet Fan Tray unit, for use in 19” equipment racks. It is designed be fitted at the top of the rack to move hot air up through the rack as required.
Page 2 Thermal Control A thermal PTC sensor is provided and will need to be plugged into the fan tray before use. The unit is factory set to operate at 30ºand will reset as the temperature falls back by 4º. Custom settings can be made using the front panel buttons. Using the alloy adhesive clip the sensor should be mounted onto an area where the sensor can pick up the ambient temperature of the equipment being cooled, and NOT directly to the main heat source.
Page 3 USER SETTING GUIDE DIGITAL THERMOSTATIC CONTROLLER MODULE These Digital Thermostatic Controller Modules are fitted in 3 products within the Penn- Elcom COOLRAC range and are used to monitor and manage all of our low noise DC fan units. PLEASE NOTE: The temperature probe must be plugged in for this unit to operate, an alarm will sound if it is not connected.