Advertisement
6. Flaps at rear of side panel on screen room are to fasten
to tent canvas at lifter mechanism. Pull tent canvas flap
away from hook & flap strips. Secure screen room flap
to tent canvas using hook & loop fasteners sewn into
both. Secure tent flap to screen room flap as shown in
FIG. 4.
FIG. 4
7. If camper does not have covers for lifter mechanism, fold
screen room flap around lifter as shown in FIG. 5.
FIG. 5
8. Align skirt at floor and wall of camper. Locate positions
of twist fasteners and mark with pencil. Drill 1/8" holes
and install twist fasteners.
9. Attach skirt to camper using twist fasteners just in-
stalled. If needed, locate wheel skirt over wheel well and
install using hook & loop fastener strips and twist fasten-
ers.
10.Secure bottom of panels by driving the hook stakes into
the ground through the appropriate grommet. (See FIG.
6)
11.Attach skirt to Screen Room with hook and loop fasteners
sewn into room and skirt (see FIG. 6)
FIG. 6
Tie straps attach
around support pole
WHEEL COVER
MOUNTING INSTRUCTIONS
1. Place the wheel cover in position to cover the wheel
opening and mark the locations of the button sockets.
2. With a 1/8" drill bit, pilot drill a shallow hole at each
marked location and install a twist fastener (provided in
plastic bag).
3. Install the wheel cover by snapping onto the twist
fasteners and turning fastener one quarter turn.
4. Take the 3 inch pieces of hook and loop strip; remove
peel strip and stick them onto the screen room skirting
opposite the hook and loop strips on the wheel cover (see
FIG. 7).
FIG. 7
Do not operate appliances venting into this
room enclosure with privacy panels closed.
At least one panel must be open for ventila-
tion when using appliances. Death or series
injury from Carbon Monoxide Poisoning
could occur if not operated properly.
4
TRIM LINE SCREEN ROOM
Twist fasteners on each side
flap and on rear skirt.
Skirt
Hook & Loop
Fasteners
Grommets
WARNING
!
Hook &
Loop
Fasteners
Advertisement
