Page 1
SUBWOOFER SERIES User Manual Systems: Sub 12 Sub 12A Sub 15 Sub 15A Sub 18 Sub 18A Sub 28 Sub 28A Sub 12i Sub 15i Sub 18i Sub C15 Sub H12 Sub H25 Sub H28 SUBWOOFER Series User Manual rev 1.00...
INSTALLING OF THIS UNIT MUST BE PERFORMED ONLY BY QUALIFIED TRAINED PERSONNEL FOLLOWING APPLICABLE SAFETY RULES. DO NOT ALLOW INSTALLATION OF THIS UNIT IF INSTALLATION HARDWARE IS BROKEN, BENT, PARTS ARE MISSING OR IS OTHERWISE DAMAGED. SUBWOOFER Series User Manual rev 1.00...
EN 55103-2:2009 /IS:2012 EN 61000-4-2:2009 EN 61000-4-3:2006 /A1:2008 /IS1:2009 /A2:2010 EN 61000-4-4:2012 EN 61000-4-5:2006 EN 61000-4-6:2014 EN 61000-4-11:2004 EN 60065:2002 /A1:2006 /A11:2008 /A2:2010 /A12:2011 Bila Tserkva, 22 January 2019 Alexey Asanov For compliance questions: info@mag-audio.com SUBWOOFER Series User Manual rev 1.00...
3. SUBWOOFER series 3.1 Introduction 3.2 SUBWOOFER series speaker models Subwoofer series serves as an ultimate low SUBWOOFER series includes following speaker frequency reinforcement range that represents models: all-purpose solutions, capable to meet the specific demands of any and all innovative projects.
Steel grill, acoustically Steel grill, acoustically Grill transparent foam transparent foam transparent foam - peak value, calculated according to AES 2 - 2012 - based on transducer power measured according to AES 2 - 2012 SUBWOOFER Series User Manual rev 1.00...
Page 11
Steel grill, acoustically Grill transparent foam transparent foam transparent foam transparent foam - peak value, calculated according to AES 2 - 2012 - based on transducer power measured according to AES 2 - 2012 SUBWOOFER Series User Manual rev 1.00...
5. System operation 5.1. Rigging Several SUBWOOFER series systems are equipped with M10 mounting points for flown installation. Rigging must be performed only by trained personnel following the established safety rules. MAXIMUM WEIGHT RESTRICTIONS MUST BE FOLLOWED AT ALL TIMES!
1. Assemble a stack of Sub 15 or Sub 18 as per paragraph 5.4. 2. Align the upper subwoofer with WSF-01 flying frame. Array mounts’ link should fit into the frame’s sockets. (Pic. 1). 3. Secure connection with four VA-0010 pins. (Pic. 2). SUBWOOFER Series User Manual rev 1.00...
3. Hang the cabinet with attached mounting planks onto the mounting plate (Pic 3, 4). 4. Use a hex key to secure the mounting bracket by tightening two M6 on the bottom of the LLS (Pic 5, 6). SUBWOOFER Series User Manual rev 1.00...
Sub 18i-4 1300 - 2600 W 8 Ohm +1 -1 30 Hz or higher, 18 dB/oct min Sub 18i-8 1300 - 2600 W 4 Ohm +1 -1 30 Hz or higher, 18 dB/oct min SUBWOOFER Series User Manual rev 1.00...
Page 16
25 Hz or higher, 18 dB/oct min Sub H28 2900 - 5800 W 4 Ohm Rear +1 -1 25 Hz or higher, 18 dB/oct min Sub H28 Link Rear +2 -2 25 Hz or higher, 18 dB/oct min SUBWOOFER Series User Manual rev 1.00...
8. CARDIOID BUTTON. Engaged on reversed subwoofer, creates sink, as it may cause the system to overheat and switch off by a cardioid coverage of a subwoofer array. itself. 9. PHASE BUTTON. Switches the polarity. SUBWOOFER Series User Manual rev 1.00...
Page 18
18. PRESET LEDS. Shows currently used preset. 16. TEMP LED. Is flashing when amplifier is at the possibility of 19. PRESET SELECT BUTTON. Switches currently selected overheating. Is lit when thermal shutdown is engaged. preset. SUBWOOFER Series User Manual rev 1.00...
SUBWOOFER series powered systems are supplied with CN-0010 PowerCon-E/F CEE 7/7 mains cable (part number 00-00005561). Use only original or supplied by manufacturer mains cables! SUBWOOFER series powered systems are equipped with PowerCon B mains power outlets for mains link to additional SUBWOOFER series powered system.
6. Standard contents Please check the complement of your SUBWOOFER series system upon receiving the package. Standard contents of SUBWOOFER series systems: SUBWOOFER CN-0010 Polyethylene Cardboard System Supplied SUBWOOFER series system series user mains cord manual Sub 12-4 Sub 12 4 Ohm passive system...
7. Accessories Various accessories are available for SUBWOOFER series systems: AM-Sub-15 AM-Sub-18 WSF-01 versatile VA-0010 8mm pin Part No. 00-00002878 array mount array mount frame Part No. 00-0006742 Part No. 00-0006741 Part No. 00-0004068 mounting bracket Part No. 00-00002647 SUB12-TB - Sub 12 transportation bag Part No. 00-0006747 SUB12A-TB - Sub 12A transportation bag Part No.
8. Warranty and assistance 8.1. Product warranty 8.2. Assistance 1. By this warranty MAG Audio grants that all There are no user-serviceable parts in your equipment manufactured under the MAG Audio device. Refer servicing to qualified technical trademark is free from defects in material, personnel.