Advertisement
Quick Links
Advertisement
Summary of Contents for Armstrong ExpressPack
- Page 1 ExpressPack® Installation and Operation Manual...
-
Page 3: Table Of Contents
Armstrong Contents General Safety Information Product Information Product Installation Options Troubleshooting Limited Warranty and Remedy... -
Page 4: General Safety Information
General Safety Information You recently purchased the ExpressPack®, and we hope you enjoy this product. Thank you for the trust you place in us. The safety instructions contained in this manual are intended for qua- lified personnel which are certified and authorized to commission, operate and maintain the device. - Page 5 The device must be stored in a dry, frost-free place, protected from shocks and vibrations. The group Armstrong International S.A., guarantees that its devices are one (1) year warranty. Armstrong’s liability will be limited exclusively to Armstrong’s repair or replacement of the part or product, excluding labor, disassembly or installation costs.
-
Page 6: Product Information
The ExpressPack® is suitable for any type of humidifier producing atmospheric steam. STEAM : the steam produced through our ExpressPack® is dry and uniformly dispersed over the whole evaporization area. MATERIAL : the header and dispersion tubes of our ExpressPack® are made in stainless steel. -
Page 7: Product Installation
Product Installation Used only in the case of a horizontal air flow, the collector must be placed horizontally, while the dispersion tubes must be placed vertically. The ExpressPack® can be located in the air handling unit or inside the duct. - Page 8 Ex- mm from the fan. To avoid stagnant Please, make sure the absorption dis- pressPack® and the first obstacle or air, do not place the ExpressPack® di- tance is met. the transition of the duct. rectly at the fan outlet.
- Page 9 Installation methods According to the purchased ExpressPack® standard, there are two different installation methods: Header located outside the duct* Header located inside the duct Mount the header with grommets under the It is necessary to introduce the ExpressPack® duct. previously assembled, before fixing its upper If the ExpressPack®...
- Page 10 The ExpressPack® is only to be used with atmospheric steam. So when installing for use with an atmospheric steam generator, minimize the length of piping between the humidifier and the ExpressPack® in order to avoid too much condensation (see the humidifier technical manual).
- Page 11 Figure 6-2. « Standard » grommet Assembly Process If the ExpressPack® is delivered disassembled, please follow the steps listed below to assemble 1. Place the header of the ExpressPack® on a plate surface 2. Put the standard grommets in the header, each grommet in a hole 3.
-
Page 12: Options
If there are many steam outlets or if you want to connect many humidifiers on the same Ex- pressPack®, you can use a tailor-made flanged steam supply manifold (optional and provided with clamps) in order to collect the steam before it’s dispersed by the ExpressPack® Figure 7. Flanged steam supply manifold... -
Page 13: Troubleshooting
Troubleshooting 1. Water «spitting» from the ExpressPack® The causes can be : A. Lift or back pressure after siphon is causing the sys- tem to flood. See chapter «Water seal for conden- B. Top of water seal is above the header of the system. -
Page 14: Limited Warranty And Remedy
Armstrong’s option, to repayment of the purchase price. As a condition of enforcing any rights or remedies relating to Armstrong products, notice of... - Page 16 Rev 3 Printed in Europe – 2019/01 © 2019 Armstrong International, SA...