Bagela BA 7000F Operating Instructions Manual page 7

Bagela Bagela
Bagela Bagela
4.2 Start-up
For engine start-up see separate operation instruction.
-
To attain the voltage required for starting the oil burner, push the accelerator lever up
-
against its maximum stop.
Engage the tumbler;
-
upper position = forward mode
middle position = neutral
lower position = reverse mode, lever must be held down
THE POSITION OF THE OPERATING LEVER CORRESPONDS TO THE TURNING
DIRECTION OF THE TUMBLER.
Before reversing the tumbler, make sure it is revolving at slow speed.
-
To avoid excessive shocks on the structure due to unbalance in the tumbler, never move
-
the lever abruptly and in a jerky manner. However, any shocks due to rough treatment will
be absorbed by the shock valves.
4.3 Charging
Fill asphalt lumps into the recycler until the hydraulic oil pressure gauge shows approx. 80
-
bar.
DO NOT OVERFILL THE RECYCLER TO AVOID EXCESSIVE SMOKE EMISSION.
4.4 Burner operation
Caution: Do not start the burner unless the tumbler is turning.
Set burner to 1st firing stage (switch position 2).
-
After about 2 minutes, when the flame has stabilised, set burner to 2nd firing stage (switch
-
position 3).
Set thermostat to the required temperature.
-
I. first burner stage max. 180°C:
II. second burner stage max. 150°C:
asphalt recycler asphalt recycler asphalt recycler asphalt recycler
   
BA 7000F / BA 10000 BA 7000F / BA 10000
BA 7000F / BA 10000 BA 7000F / BA 10000
5
red pointer
green pointer
   