ADEMCO TS300 Installation And Operating Instructions

®
INSTALLATION AND OPERATING INSTRUCTIONS
INTRODUCTION
The TS300 is a hardwired temperature monitor able to accurately detect variations in temperature. It can monitor
the temperature at the unit and at a remote location (using a T280R) simultaneously. Alarm annunciations include
a local piezo sounder and two programmable NO/NC outputs which activate when the mapped high or the low
limit(s) are exceeded, protecting equipment, property, and perishable items. The NO/NC alarm outputs may be
delayed by increments of one minute to allow for expected momentary temperature variations such as during a
refrigeration unit's defrost cycle. The audible alert, if programmed, sounds when the temperature limit is violated and
can be silenced with the press of a button for a programmed duration. The TS300 can accurately monitor any
temperature within the range from 32
to monitor temperature within the range from -40
environment
.
INSTALLATION
Mount the unit on a wall at a convenient viewing height. For accurate temperature sensing at the unit, do not mount
the TS300 near any heat or cooling source. If the unit does not trip the panel, insure that the contact configuration
(NO/NC) as defined in the Setup Procedure agrees with that of the zone to which it is connected.
TO THE INSTALLER
Regular maintenance by the installer and frequent testing by the user are vital to continuous satisfactory operation
of any alarm system. The TS300 and the T280R should be tested periodically, at least once a month, depending
on conditions. The installer should assume the responsibility of developing and offering a regular maintenance
program to the user as well as acquainting the user with the proper operation and limitations of the alarm system
and its component parts. Recommendations must be included for a specific program of frequent testing to ensure
the system's proper operation at all times
SETUP PROCEDURE
Remove the front cover from the TS300. With power applied to the unit, press the SETUP MODE switch (see
Illustration A). Press the Left button to lower a numeric limit by a value of one (press and hold to decrement by tens).
Press the Right button to raise a numeric limit by a value of one (press and hold to increment by tens). Pressing
either button will toggle the either/or choices. When your preferred setting is displayed, press the setup button to
accept and move to the next parameter. Table 1 shows what is seen on the display for each programmable
parameter. Note that, when setting High/Low limits in Centigrade mode, incrementing/decrementing will raise/lower
the limit by the equivalent of 1
° ° °
F to 140 F (0 C to 60
°
F to 140
.
Left Button Lowers
Numeric Values
Setup Mode Button
Illustration A
° °
Fahrenheit (or 10 F, if button is pressed and held).
DUAL TEMPERATURE SENSOR
°
C). A T280R Remote Temperature Probe may be used
° ° °
F (-40 C to 60 C) or to monitor temperature in a harsh
Right Button Raises
Numeric Values
+
Remote
Remote
Tamper
Tamper
Output 1
Common
Output2
Common
Tamper Switch
N8188-2 4/97