Table of Contents
Advertisement
DEBUG
PORT
12) LED_C1/LED_C2 (RGB LED Strip Headers)
The headers can be used to connect a standard 5050 RGB LED strip (12V/G/R/B), with maximum power
DEBUG
rating of 2A (12V) and maximum length of 2m.
PORT
13) SATA3 0/1/2/3/4/5/6/7 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
RAID 1, RAID 5, and RAID 10. Refer to Chapter 3, "Configuring a RAID Set," for instructions on configuring
a RAID array.
1
1
DEBUG
PORT
1
LED_C1
1
LED_C2
RGB
LED
Strip
1
12V
Before installing the devices, be sure to turn off the devices and your computer. Unplug the power
cord from the power outlet to prevent damage to the devices.
SATA3
0
1
7
7
7
7
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Peripherals\PCH
SATA Configuration," for more information.
Pin No. Definition
1
12V
2
G
3
R
4
B
Connect one end of the RGB LED strip extension cable to the
header and the other end to your RGB LED strip. The black wire
(marked with a triangle on the plug) of the extension cable must be
connected to Pin 1 (12V) of this header. The 12V pin (marked with
an arrow) on the other end of the extension cable must be lined
up with the 12V of the LED strip. Be careful with the connection
orientation of the LED strip; incorrect connection may lead to the
damage of the LED strip.
SATA3
3 5 7
2 4 6
- 19 -
Chipset supports RAID 0,
®
Pin No. Definition
1
GND
2
TXP
3
TXN
1
4
GND
1
5
RXN
6
RXP
7
GND
Advertisement
Table of Contents
