Advertisement
Instruction / Installation Sheet
Expandable Media Box
with Duplex Receptacle
Part # 45-0051-WH CONTINUED
Installation Instructions:
Fig. 1
Figure 2:
Fig. 2
Refer to the included template to make your cutout. Once you have made the
cutout, return to Figure 3 of this instruction sheet and complete installation.
Fig. 3
Figure 3:
Run the source of power to the included Old Work Electrical Box. Be sure to follow all
local electrical codes.
Figure 4:
Fig. 4
Connect the supplied Duplex Receptacle to a piece of 14/2 with ground UL approved
electrical building wire that you have pulled from a power source. Strip off approximately 3
inches of the outer jacket of the wire. Be careful not to cut the jacket of the inner wires.
Connect the hot line (black) wire to the brass colored terminal screw and neutral (white)
wire to the silver colored terminal screw. Be sure to connect the grounding (green) or bare
grounding wire to the green colored terminal screw. Once you have wired the Duplex
Receptacle, screw it into the Old Work Electrical Box until the receptacle is firmly secured.
Fig. 5
Figure 5:
Use the four provided screws to secure the Old Work Electrical Box and Receptacle
to the mounting studs on the back side of the Expandable Media Box.
Figure 6:
Fig. 6
Important: Before installing the Expandable Media Plate into the template opening, make
sure to pull your low voltage cables through the low voltage cable opening.
After pulling low voltage cables through: Insert the receptacle side of the
Expandable Media Box first, slowly sliding it into the opening. Be sure the four (4) metal
wings are folded in and swing the right side of the Media Box into position until the entire
Media Box is flush with the wall. Now screw down the screws with wings; these wings
fasten tightly against the back of the drywall. Push Expandable Cavity into place.
Fig. 7
Figure 7:
Your new Expandable Media Box with Duplex Receptacle is now installed and ready for
the TV mount to be installed. Install your TV mount bracket per the TV bracket
manufacturer's instructions.
Figure 1:
Top view - shows needed space between the
drywall and the studs.
Page 2 of 2
888.223.7977
770.662.8205
www.DataCommElectronics.com
05/01/2014
Advertisement
