Advertisement
Quick Links
Advertisement
Summary of Contents for Inductosense Wand Echo 45
- Page 1 WAND ECHO 45 Installation & User Manual Document: 14.05.19 REV.1 Document: 1.04.04 Rev5...
- Page 2 How to use this manual This manual addresses best practise and the recommended approach for ECHO Inductosense Ltd does not warrant that the TMS sensors are suited to all environments installation. and applications. Inductosense Ltd makes no warranty and representation, either...
- Page 3 ECHO 45. where the number relates to the cable length of the device. Figure 1 (Right and below): The WAND ECHO 45 pictured, allows the activation point for WAND sensors to be offset to accommodate bulky insulation or cladding layers or to simplify monitoring of hard to access locations.
-
Page 4: Installation
INSTALLATION 5. Remove the paper backing from the UHB tape disc and apply over the top of the ECHO sensor. Press firmly to ensure that a good seal is formed around the ECHO. 1. Locate the sensor over which the ECHO is to be installed, removing any covering insulation 6. - Page 5 Figure 3: ECHO fully installed with the metal clad inslulation layer reapplied. Note the RFID tag co-located with the ECHO activation pad. Installing an RFID The RFID must be applied relative to the ECHO measurement coil in an orientation which allows detection by the WAND probe.
- Page 6 Indusctosense Limited Unit DX, St Philips Central Albert Road, Bristol, BS2 0XJ United Kingdom Office: +44(0)1174034047 info@inductosense.com www.inductosense.com @inductosense Registered in England and Wales with registered number 09689612 and VAT registered number 227006245 Document: 1.04.04 Rev5...