Table of Contents
Advertisement
Thunder Heart Performance Corp.
CHAPTER 3
10
4. With the heat shrink tubing installed, use a heat gun to shrink the tubing.
Start at the EHC connector and work to the other end.
5. Start to re-fit the harness to the bike by plugging in the rear harness
connector into the EHC.
6. Move along the harness and attach it to the bike where necessary.
7. Cut the ends of the harness to length (remember to allow room for
movement and strain relief).
8. Strip the ends of the harness.
9. Attach the terminals to the wire ends and use a heat gun to shrink the
strain reliefs.
Note: If no colored shrink tubing is attached to a terminal, use the black 1" pieces
supplied with the kit.
10. Repeat the process for the other three harnesses.
INDICATORS AND INSTRUMENTATION
Indicator Options
The EHC is designed to control LED-type dash indicators. LEDs are brighter,
vibration resistant, more power efficient, usually don't need to be replaced,
and are generally easier to mount on a custom bike. When a Thunder Heart
Performance LED indicator panel is used (such as P/N RSE4088), simply
find a suitable mounting location and plug the supplied 16" cable (72" cable is
optional P/N RSE4145) into the EHC.
Speedometer Options
Thunder Heart also offers adapter harnesses for use with Dakota Digital
speedometers (built-in indicators). See Appendix B, "Optional and
Replacement Parts" for the correct harness for your application.
615-672-8811
Figure 16—EA4088
EI4250
www.thunder-heart.com
Hide quick links:
Advertisement
Table of Contents
