1. SAFETY WARNINGS WARNING― Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. WARNING― Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. WARNING―...
Page 4
2. INSTALLTION When selec ng a posi on for your unit you should make sure the floor is flat and firm, and the room is well ven lated. Avoid loca ng your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it may increase the electrical consump on.Extreme cold ambient temperatures may also cause the unit not to perform properly.
Page 5
2) Remove the screws fixed the top-hinge with cross-slot screwdriver. 3) Replace the top-hinge and the top-door limit block and the door bearing bush to the other side. Remove the nut with sleeve.Take off the washer then remove the axes to the other side and fixed.
Page 6
4) Disassemble the screws fixed the bottom-hinge with Hexagonal socket wrench. Note:the refrigerator-freezer incline angle less 45°. 5) Replace the bo om hinge to the other side then fix it with screws. 6) Set the door right posi on,fix the mid-hinge.
Page 7
7) Replace the top-hinge. 8) Set the top door right position,fix the top-hinge and the cover. 9) Replace the leveler to the other side and adjust it to make sure the cabinet level.
Page 9
*All images in this instruc on manual are for indica on only; please refer to your individual unit for details.