Sony DRU-700A Operating Instructions Manual page 12

3
Connect the cables.
• Connect an unused power connector from the computer's power supply to
the DC input (power input) connector of the drive.
• Connect the supplied IDE flat cable to the IDE connector of the drive.
Hint
If your computer supports digital playback, you do not need to connect the audio cable
to the analog audio connector. Most computers support digital playback at this time.
Analog audio
connector
Notes
• The side of the IDE flat cable with the red line indicates the pin 1 conductor. Verify that
the pin 1 side is connected to pin 1 on the motherboard.
• The power connector must be inserted with the inclined side upwards.
• If there is no spare power connector, you must use a "Y" adapter.
12
Pin1
IDE connector
IDE flat cable
DC input connector
DC INPUT
5V GND12V
Power connector
Red (pin 1)
To computer
motherboard