Summary of Contents for elem MTBT59-CC139L
- Page 1 Original Instructions TILLER THERMAL MTBT59-CC139L S44 M11 Y2018 Read this manual carefully before putting the unit in operation This machine is delivered WITHOUT OIL OR GASOLINE in the engine...
- Page 2 ■1. Unit The lightweight tiller is together with a high-efficient 4 strike engine. This design is ideal for tilling close-planted crops with semi-hard soils. When in operation, it runs steady and is quite silent. The tiller is made of a little special wearable steel so it provides for good cost-effectiveness. A special shape of blades provides for thrifty and efficient tilling.
- Page 3 area. Prevent other person from any contact with the machine. 3. Make provision for the tools storage. The machines not in current use should be kept in a dry place, elevated or locked where practicable so that any access to them is prevented. 4.
- Page 4 c) Never work while people, especially children, or pets are nearby; d) Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. 2) Preparation a) While working. Always wear substantial footwear and long trousers. Do not operate the equipment when barefoot or wearing open sandals;...
- Page 5 storage area free of vegetative material and excessive grease; e) Replace worn or damaged parts for safety; If the fuel tank has to be drained, this shall be done outdoors.
- Page 6 SYMBOLS Risk of injury caused by Denotes risk of personal rotating machine parts! injury or damage to the tool. Clutch handle released, unit is running in idle. Read manual before use Choke, cold start setting Wear goggles and ear Maximum motor defenders when using the revolutions device.
- Page 7 Stop the engine When repairing, please before refueling take out the spark plug. Then repair according to the operation manual. Guaranteed sound power EC accordance with European standards of safety enforcement ◆2.1 Emergency action Apply the first aid adequate to the injury and get qualified medical assistance as quickly as possible.
- Page 8 2.3.4 Noise hazard Hazard Description Protective Residual hazards Hearing impairment Frequent or prolonged work Wear ear with unit without wearing ear protectors protectors may result in hearing impairment 2.3.5 Vibration hazard Hazard Description Protective Residual hazards Entire body Working with the unit for Have regular breaks vibration a prolonged period may...
- Page 9 2.4.3 Training Use of the unit requires adequate lesson by a professional or the use of the manual only. Special training is not required. ■3.Technical data Engine design 4 strike OHV Max. rotational speed :3000 min Engine displacement 2,6 kW/139cm³ Working width 590 mm Max.
- Page 10 ■4.Tansportation and storage ●The unit is allowed to be transported with the engine off only. ●Clean the unit thoroughly before putting in on storage. ●Store the unit at a dry clean place. ■5.Assembly Structural group 1 Delivery –contained Parts and accessories Fig 1 –...
- Page 11 Structural group 3 Required structural Delivered parts and groups accessories Structural group 2 Fig 1 – pos.5 Structural group 4 Required structural Delivered parts and groups accessories Structural group 3 Fig 1 – pos.2 Fig 1 – pos.7 Structural group 5 Required Delivered parts...
- Page 12 Refueling Use only regular leadless petrol Flg.8 Explosion hazard! Refuel outdoors only! Never refuel with engine running or while it is still hot! Do not smoke and do rot handle open fire. Engine oil filling Use only oil type 15W40! Use oil dip rod to check the filling status.
- Page 13 Switching unit on/off Put the lever on the chute (fig.11).pull the starter cable evenly. The engine should start up after 3-5 pulls. Put the lever at the required speed and pull the driving lever (fig 11) against the handle (fig.12). Notice: if the engine is heated up, it is possible to start up in the slow/fats position.
- Page 14 ■7. TROUBLES-CAUSES-TROUBLESHOOTING Trouble Cause Troubleshooting Engine will not 1. Empty tank 1. fill in the tank, check the fuel in start 2. fouled air filter carburetor, defecate the tank and 3. no ignition spark clean the hole in the lid with a needle 4.
-
Page 15: Inspection And Maintenance Schedule
■8. INSPECTIONS AND MAINTENANCE ◆8.1 INSPECTIONS AND MAINTENANCE SAFETY INSTRUCTIONS The machine will serve as a sufficient aid only if maintained and care for appropriately. Insufficient maintenance and care may result in accidents and injuries. ●Prior to any works on the unit, always switch the engine off and pull the sparkle plug socket out! ●Never use aggressive detergent for cleaning. -
Page 16: Service Department
Exploded views and information on spare parts can also be found www.eco-repa.com under: ELEM GARDEN TECHNIC application service team will gladly answer questions concerning our products and their accessories : sav@eco-repa.com STORAGE Risk of fire ! Store your Electric Hoe away from fuels, oils, grease and gases. - Page 19 2018 Declaration of Conformity We “ELEM GARDEN TECHNIC” hereby declare that the machine described below complies with the relevant basic safety and health requirements of the EU Directives, both in its basic design and construction as well as in the version put into circulation by us. This declaration shall cease to be valid if the machine is modified without our prior approval.
- Page 20 81, rue de Gozée 6110 Montigny-le-Tilleul Belgique Tél : 0032 71 29 70 70 Fax : 0032 71 29 70 86 Made in China S.A.V sav@eco-repa.com Service Parts separated 32 / 71 / 29 . 70 . 83 32 / 71 / 29 . 70 . 86 Made in China 2018 Drawings, descriptions and photos are non-contractual and subject to change.