Scotts LST01562S Owner's Manual page 7

REWINDING SPOOL FROM BULK LINE
(USE ONLY .080" DIAMETER LINE)
Bulk line for your trimmer is available at extra cost
from your local dealer. To install bulk line, follow these
steps:
•
Turn off the trimmer and remove the battery.
•
Cut line to a length of 14.7 feet.
•
Press the release tabs on the line spool cover as
shown in Fig. 1, and remove the spool by pulling it
straight off. Remove and discard all line on the
spool.
•
Rotate the spool knob so that the 2 holes in the
spool hub are aligned with the holes in the 2 metal
eyelets.
•
Insert the line through all four holes. Pull the line
until there is an equal length of the line on each
side of the spool. (See Fig. 2)
•
Turn the spool knob in a clockwise direction (see
arrows on the top of the knob) until the line is
wound to the proper cutting length. (See Fig. 3)
•
Install the spool back into the spool cover making
sure it is firmly locked in place. (See Fig. 4)
OPERATING
Release tab
Fig.1
7
Model LST01562S
Line
Fig. 2
Spool knob
Fig. 3
Fig. 4