Disc Tray; Eject Button; Busy Indicator - Sony DRU-800A Operating Instructions Manual

A Disc tray
Insert discs here, label side up.
Hint
When you insert a disc into the drive, make
sure that it is under the four pins. When using
the drive vertically, make sure that you set the
disc inside the two lower pins.
B Eject button
Press to open and close the disc tray.
C Busy indicator
Indicates the drive status.
Lit : The drive is reading data,
playing back an audio CD, or
writing packets.
Blinking: The drive is writing data
(disc-at-once, track-at-once),
formatting a disc, or
deleting
Off : The drive is in a state other
than those outlined above.
1)
Some drives indicate this state with the lit
indicator.
D Emergency eject hole
If you cannot open the disc tray with the
eject button, turn off your computer, and
then insert a thin, elongated object into
this hole to eject the disc tray manually.
1)
data from a disc.
About 40 mm (1.6 in)
E Do not use.
F Do not use.
G Analog audio connector
Analog stereo audio output. Using an
audio cable, connect to the audio
connector of a computer with a sound
card.
Note
Connecting a cable other than an audio
cable or otherwise misusing the audio
connector may cause damage to the
product.
H Jumper
A jumper is set on the appropriate pins
before connecting the drive.
CS EL
SLAVE
MASTER
Jumper pins
I IDE connector
Connect to the computer with the
supplied IDE flat cable.
J Pin 1
The location of this pin determines the
proper orientation of the connection
cable.
K Power connector
Connect the connector of the computer's
internal power supply.
DC INPUT
5V GND 12V
CS EL
SLAVE
MASTER
Jumper pins
9