Advertisement
Step 4.
Path: Menu - Basic - VehiInfo
Here you can set basic vehicle details.
When complete, highlight "OK" and press enter.
Step 5.
Path: Basic - DateTime
Ensure that the correct settings are entered for
your region, the time and date can be
synchronised from satellite via G.P.S.
When complete, highlight "OK" and press enter.
Step 6.
Path: Menu - Basic - On/Off - CTRL
Here, the parameters for when the device will switch
on/off can be adjusted.
Ignore – Device will ignore vehicle ignition setting.
Delay – Time to remain on after ignition off.
Timing – Timed on/off programs (24 hr clock)
When complete, highlight "OK" and press enter.
Step 7.
Path: Menu - Basic - On/Off - VOLT
The device will detect the vehicle voltage automatically, when the
battery voltage is lower than the Shut.Volt, the device will shut
down, to avoid draining the battery. When the voltage is higher than
the PowerVolt, the device will power on, and begin recording.
Powertype – Please set this to AUTO
Shut Volt – Voltage when device will power off.
Power Volt – Voltage when device will power on.
When complete, highlight "OK" and press enter.
Step 8.
Path: Menu - Record - Mode
Select PAL or NTSC to suit camera type.
Each camera fitted must be marked valid/enable.
Camera types (960H/720P) are set in pairs.
When complete, highlight "OK" and press enter.
Vehicle Info.
Time / Date
On/Off Settings
On/Off Settings
Camera Type
Advertisement
