Downloading Labels To The Ultra Contact Reader - PakSense Ultra Contact Series User Manual

Understanding the Ultra Contact Reader
Ultra Contact Reader
1. Probe Pins
2. Power Status
LED Indicator
3. Probe/Power Switch
4. Release Button
5. USB Connection
Point
1. USB Connection Point – USB cable connection point from reader to computer. While the reader is
downloading data to a computer, the Power Status LED indicator will be OFF and the USB LED will be ON.
Do not connect USB cable to computer while reading labels.
2. Release Button – holds Probe/Power Switch in place during reading. Press this button down and slide
back on the Probe/Power Switch to retract the pins into the reader when not in use.
3. Power Status LED Indicator – solid GREEN indicates that power is on. A solid RED light indicates a low
battery.
4. Read Status LED Indicator – The Read Status LED indicator will flash when information is being read from
the label.
5. Probe Pins – pins should be pressed down fully and fully on to the corresponding red circles on the
PakSense Ultra Contact Label to insure a successful read. The label's plastic pouching should be pierced.
Note that the pins have sharp tips and must be handled with care.
6. Probe/Power Switch – used to turn the reader on and to move the probe pins forward for reading labels.
Slide back to retract the probe pins when not in use.
7. USB LED – this light will be lit any time the USB cable is connected. A flashing GREEN USB LED
indicates a USB error. Labels cannot be read while the reader is plugged into the computer via the USB.
8. Reset Button – located on the back of the reader inside the battery door. To reset and clear the memory
of the reader, remove the batteries, replace the batteries, and then press the reset button. The Read Status
Indicator and Power Status Indicator will both flash to indicate a successful reset.
Distributed by MicroDAQ.com, Ltd.
Front View
7. Read Status
LED Indicator
6. USB LED
Back View
7
www.MicroDAQ.com
8. Reset Button
5. USB Connection
Point
(603) 746-5524