Advertisement
Quick Links
Configuring your display
1 Visit www.lascarelectronics.com/software/panelpilot-m
to download PanelPilot M software onto your PC.
2 Connect the device to your PC using a standard
mini USB cable - CABLE USB A-MF (not supplied).
3 Open up the software on your PC and follow
step-by-step instructions for configuring
your display.
Dual-In-Line IDC (DIL Connector)
The DIL IDC socket provides an alternative connection method
to the screw-terminals. It also includes provision for future
expansion using data buses and alarm outputs. Visit
www.panelpilot.com for information on which features are
currently supported. The pin-out is as follows:
Further Information
Visit www.lascarelectronics.com/panelpilot for further
information on the PanelPilot platform and to download
a datasheet for your particular display. This will include
specific information about pin configurations, wiring
instructions and mounting method.
M
M
M
Quickstart Guide
Issue 2
07/2018
Advertisement
Summary of Contents for Lascar Electronics PanelPilot
- Page 1 Configuring your display 1 Visit www.lascarelectronics.com/software/panelpilot-m to download PanelPilot M software onto your PC. 2 Connect the device to your PC using a standard mini USB cable - CABLE USB A-MF (not supplied). 3 Open up the software on your PC and follow step-by-step instructions for configuring your display.
- Page 2 Screw Terminal Connection Getting to know your display There are four screw terminals for connecting single and dual All PanelPilot compatible displays share the following input applications. They are labelled 1 to 4 as follows: features: Mounting bezel N.B. For safety reasons, the meter should be isolated from both the supply and signal voltages before connecting the USB.