TJERNLUND Hot Shot 950-9200 Owner's Instructions

TJERNLUND PRODUCTS, INC.
1601 Ninth Street • White Bear Lake, MN 55110-6794
PHONE (800) 255-4208 • (651) 426-2993 • FAX (651) 426-9547
Visit our web site • www.tjernlund.com
READ OWNERS INSTRUCTIONS CAREFULLY PRIOR TO INSTALLATION.
THESE INSTRUCTIONS MUST REMAIN WITH EQUIPMENT. DO NOT DESTROY.
Hot Shot™ Universal Stove Blower Heat Shield, P/N (950-9200)
Tjernlund's Hot Shot™ Universal Stove Blower Heat Shield allows for the proper installation of the fan on stoves which do
not have an existing heat shield.
ATTACHING HEAT SHIELD TO BLOWER HOUSING
1. Unscrew and remove Stove Top Edge Clip from the heat shield bracket, (See Figure A). Save for later use in Step 7.
2. Unscrew the (2) brackets from the inside of the heat shield, (See Figure B).
3. Separate the SB1 main blower housing and the back cover by removing the (6) screws that attach them, (See Figure C).
FIGURE A
4. Attach the (2) brackets removed from the heat shield in Step 2 to the outside front of the main blower housing. Insert
screws through housing from inside the SB1 main blower housing and screw into the (2) feet of each bracket, (See
Figures D and E).
5. Reattach the back cover to the SB1 main blower housing with (6) screws removed in Step 3, (See Figures E and F).
FIGURE D
©2011 TJERNLUND PRODUCTS, INC. ALL RIGHTS RESERVED
DESCRIPTION
INSTALLATION
FIGURE B
BRACKETS
ATTACHED
FIGURE E
HEAT
SHIELD
FIGURE C
FIGURE F
P/N: 8504184