Table of Contents
Advertisement
Quick Links
DMG-501 & 620– Waterbased Paint Dryer System
Read and follow all instructions and Safety
Precautions before using this equipment
Description
The DMG-620 Dryer System consists of a stand
and 2 DMG-501 Dryer Guns (also available
separately). These products have been developed
for accelerated drying of waterbased paints,
reduce drying times and increase productivity.
The Dryer uses the Coanda principle, amplifying
the airflow though the device from a low input of air
into the Handle. A replaceable filter is included to
trap any airborne debris from contaminating the
paint finish.
The DMG Air Dyer System complies to ATEX
regulations 94/9/EC, protection level; II 2 G X,
Suitable for use in Zones 1 and 2.
Product Specification
DMG-501 Dryer
Max inlet pressure
Typical Air consumption
3.5 bar
DMG-520 Stand
Max inlet pressure
Hose attachment by QD
Operation Manual
Important
7 bar
325 litre/min @
7 bar
SB-E-3-150 iss. 5
to
© 2012 Finishing Brands UK Ltd.
1
Advertisement
Table of Contents
Related Manuals for DeVilbiss DMG-501
Summary of Contents for DeVilbiss DMG-501
- Page 1 SB-E-3-150 iss. 5 Operation Manual DMG-501 & 620– Waterbased Paint Dryer System Important Read and follow all instructions and Safety Precautions before using this equipment Description The DMG-620 Dryer System consists of a stand and 2 DMG-501 Dryer Guns (also available separately).
-
Page 2: Safety Warnings
Installation and Operation Assembly would supply to the spraygun). 1. Fit 4 legs to base (3). Fit lower The DeVilbiss range of DVFR stand upright into base and Filter/Regulators tighten with thumbscrew. - Page 3 Stand Assembly Clamp Assemblies Maintenance The only maintenance required is to ensure the equipment is kept clean and free from paint contamination. Regularly check the filter. If the filter is blocked it will restrict the airflow and reduce the drying effect. When contaminated, dispose of the filter and use a new replacement.
-
Page 4: Ec Declaration Of Conformity
Spare Parts DMG-501-K Air Dryer Filter pack of 3 DMG-5-K3 Male QD MPV-5 Spare Parts DMG-520-K Stand Assembly Stand Base Stand upright Clamp Assembly Extension Arm Hose assembly H-7501HA-1.2 Thumbscrew Female QD MPV-424 EC Declaration of Conformity We: Finishing Brands UK Limited., Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as...
Need help?
Do you have a question about the DMG-501 and is the answer not in the manual?
Questions and answers