Safe Stop Procedure; Safety - WEST 1600 Manual

•
Make sure handbrake is fully applied.
•
Make sure all controls and equipment is left safe.
•
Stop the engine.
•
Remove the key.
Always use SAFE STOP:
•
Before leaving your seat; or
•
When anyone else approaches; or
•
When anyone else is working on the machine.
You need to take extra precautions when safe stop is not possible.
1. Keep all personnel clear of machine when spreading or manoeuvring
2. Do not permit anyone to ride on machine.
3. Never enter machine to clear blockages unless the SAFE STOP PROCEDURE has been followed and P.T.O. drive
shaft disconnected at the tractor end before carrying out adjustments, inspections or service.
4. Always disconnect the P.T.O drive shaft at the tractor end before carrying out adjustments, inspections or service.
5. In use keep all guards in place, they are for your protection and ensure that the P.T.O shaft guard chains are secure.
6. P.T.O Drive Shaft – check there is a minimum overlap of 150mm of the lemon section tubes and that these tubes do
not bottom on full lock. Should the tubes need shortening cut equal amounts from each tube and the plastic guard
tubes.
7. Check tractor is large enough to control the machine in all conditions, do not overload the spreader.
8. Check hydraulic circuits functioning, especially the brakes. Hoses need to be checked periodically for excessive
cracking or damage that may compromise their functionality. Always ensure SAFE STOP PROCEDURE is in place.
9. Foreign bodies in manure – the machine can throw stones or other objects a great distance. Ensure the machine is kept
well clear of people, roads and buildings.
10. Rotor tips and channels – check for wear and damage. Replace as necessary.
11.
Disengage P.T.O clutch when turning sharp corners.
12.
Operation of lights must be checked periodically.
13.
The driver must not exceed 20mph while towing this machine.
14.
Care must be taken when traversing across any land with an incline of greater than 5 degrees, as there is a danger of
the vehicle overturning.
15.
Tyre pressure must be maintained for safe use of machinery.

SAFE STOP PROCEDURE

SAFETY

2