Table of Contents
Advertisement
Quick Links
SCREW COMPRESSORS
20R/30R
This Instructions only contains bare shaft machine information.
It is imperative to have in complement the accessories instructions, also the parts list before
installing the equipment.
TYPHON II screw compressors are covered 24 months by warranty within the limits mentioned in our General Sales Conditions. The use of
the BSC3 oil carries our warranty from 24 to 36 months. In case of a use other than that mentioned in the Instructions manual, and without
preliminary agreement of MOUVEX, warranty will be canceled.
Z.I. La Plaine des Isles - F 89000 AUXERRE - FRANCE
Tel. : +33 (0)3.86.49.86.30 - Fax : +33 (0)3.86.49.87.17
contact@mouvex.com - www.mouvex.com
TYPHON II
13R/15L - 19R22L
20R/30R SAE4
WARRANTY :
INSTRUCTIONS 1401-G00 e
Section
1401
Effective
October 2018
Replaces
February 2016
Original instructions
OPERATION
MAINTENANCE
SAFETY
Your distributor :
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Mouvex Typhon II
Summary of Contents for Mouvex Typhon II
- Page 1 WARRANTY : TYPHON II screw compressors are covered 24 months by warranty within the limits mentioned in our General Sales Conditions. The use of the BSC3 oil carries our warranty from 24 to 36 months. In case of a use other than that mentioned in the Instructions manual, and without preliminary agreement of MOUVEX, warranty will be canceled.
-
Page 2: Table Of Contents
ADDITIONAL DOCUMENTATION REMARKS : The table below gives the list of instructions in addition MOUVEX truck screw-type compressors MUST be installed in sys- to this central instruction : tems designed by qualified personnel. The installation MUST be in compliance with local standards, national regulations and rules of safety. - Page 3 THE END USERS MUST USE, WHEN NECESSARY APPROPRIATE EAR PROTECTIONS. FAILURE TO WEAR HEAR PROTECTIONS AREAS WHERE NOISE A loud noise can HIGHER THAN 80 DBA CAN LEAD TO cause permanent PERMANENT BODY DAMAGE. body damage. NT 1401-G00 10 18 TYPHON II e 3/16...
-
Page 4: Overall Dimensions
1. OVERALL DIMENSIONS 20R - 30R NT 1401-G00 10 18 TYPHON II e 4/16... - Page 5 1. OVERALL DIMENSIONS (continued) 13R/15L - 19R/22L NT 1401-G00 10 18 TYPHON II e 5/16...
- Page 6 1. OVERALL DIMENSIONS (continued) 20R/30R SAE4 NT 1401-G00 10 18 TYPHON II e 6/16...
-
Page 7: General Data
Thanks to this sys- tem, the installation is lighter and saves space on the side of the vehicle for other accessories. TYPHON II version 30R can be directly driven by an electric or hydraulic motor, and can be driven by a diesel motor. -
Page 8: Technical Characteristics
RACTERISTICS temperature 20°C, atmospheric pressure : 1013 mbars. on mounting and packaging of the TYPHON II compres- sors, in order to be able to benefit from the guarantees TYPHON II for these pieces of equipment. - Page 9 2. GENERAL DATA (continued) 2.3.1 CONDITIONS AT SUCTION 2.3.2 CONDITIONS AT DISCHARGE The TYPHON II compressor must be protected by a valve Speed (rpm) : that protects the compressor against accidental over- pressure. 1200 1600 1600 2000 TYPHON II N-20R...
- Page 10 The shafts of the motors driving the TYPHON II com- pressors must be aligned within one angle degree on the TYPHON II shaft. In the case universal joint drive, the motor and compressor side shafts must be parallel with- in one degree.
-
Page 11: Multiplier 13R/15L - 19R/22L
3. MULTIPLIER 13R/15L - 19R/22L 3.1 Cross-section Front view of compressor NT 1401-G00 10 18 TYPHON II e 11/16... -
Page 12: Multiplier Mounting
M10 in the multiplier. from the from the drive shaft before starting to assemble. • Mount the multiplier on the compressor : • Prepare the compressor N20R or N30R from MOUVEX : - Mount the headless screw 839. - Drain the compressor oil. - Page 13 834 keeping the lid in place 3. Screw at torque 24 Nm + 10%. - Unscrew the screw holding the fan in place 819. Inject a drop of Loctite ® 243*. Replace the screw. * Loctite ® is a registered trademark. NT 1401-G00 10 18 TYPHON II e 13/16...
-
Page 14: Use Of Compressor
A start up oil change has to be made after one week or • TYPHON II 20R - 30R ..6 l 10 working hours. Not performing this oil change will void the warranty. -
Page 15: Operation
ALWAYS DISENGAGE THE DRIVE BEFORE SLOWING ENGINE DOWN. • Release the clutch. NOTICE : COMPRESSOR MUST OPERATE AT FIXED SPEED WITHIN THECOMPRESSOR MODEL SPEEDLIMITS. SPEED MUST REMAINCONSTANT THROUGHOUT THE OFF LOADING OPERATION. NT 1401-G00 10 18 TYPHON II e 15/16... -
Page 16: Maintenance
CAUTION THE BLOWING OF OIL GAUGE CAN CAUSE PERSONNAL INJURY OR PRO- PERTY DAMMAGE. IT IS MANDATORY TO CARRY APPROPRIATE PROTEC- TIONS (GLOVES, GLASSES...) TO AVOID RISKS OF PERSONNAL INJURY. Blowing direction NT 1401-G00 10 18 TYPHON II e 16/16...
Need help?
Do you have a question about the Typhon II and is the answer not in the manual?
Questions and answers