Schaeff Echo 3000 Service Manual page 4

E
2. Align the cutouts on the front edge of the top
cover with the front posts of the overhead
guard. Move the front edge of the top cover
into place. Lower the rear of the top cover
into place.
3. Align the cut-outs in the lip of the cover with
the spring clips on the truck frame.
4. Press downward at each spring clip until the
cover is secured.
5. Connect the battery.
CONTROL COVER
Removal
1. Disconnect the battery and discharge the
capacitors.
2. Remove the top cover (refer to TOP COVER
Removal procedure in this section).
3. Remove the steering tiller.
4. Remove the seven screws securing the
control cover.
5. Lift the control cover over the control handle
and remove it from the truck.
Replacement
1. Place the control cover into position over the
control handle and start the seven screws - do
not tighten.
2. Install the steering tiller.
3. Position the cover so there is no contact with
the control handle boot or steer tiller, then
tighten the seven screws.
4. Replace the top cover (refer to TOP COVER
Replacement procedure in this section).
5. Connect the battery.
OPERATOR COMPARTMENT PADS
Removal
NOTE
The pads in the operator compartment are
secured in place with dual-lock fasteners.
When removing the pads, use care to avoid
detaching the fastener from either the pad or
REV W1 11/02/99
C
lectric ounterbalance
H O
igh utput
the frame of the truck. If the fastener does
come loose, clean the area with isopropyl
alcohol and reattach it with cyanoacrylate
adhesive ("super glue").
1. Remove the top cover.
2. Grasp the outside edge of the pad and
carefully separate the pad from the mating
portion of the fastener attached to the frame
of the truck.
3. Rotate the pad outward until the remainder of
the fasteners release.
4. Remove the pad.
Replacement
Refer to PADS AND PLASTIC in the FRAME
section of the PARTS Manual for location of
operator compartment pads.
1. Align the pad so the halves of the fasteners
meet.
2. Firmly press the pad into place.
3. Gently pull on the outside edges of the pad to
verify the attachment.
4. Install the top cover.
FLOOR MAT / BRAKE PEDAL PAD
The floor mat in the operator compartment is
not glued down. However, normal servicing of
the truck does not require the removal of the
floor mat.
Removal
The brake pedal pad is secured in place with
general purpose RTV silicone adhesive. The
brake pedal pad will be damaged when
removed.
replacement pad be available prior to removal
of the old pad.
1. Using an appropriate scraper, pry up the
outside edge of the pad.
2. Carefully peel the pad away from the brake
pedal.
1.3
NOTE
NOTE
NOTE
It is recommended
Frame
that a