Adjustment Of The Printer - Wow SparkMaker SLA Operating Manual

Place the air-dried model on a
UV light or sunlight for about 10
minutes.
＊ Notice：
❶ In order to prevent the model from being
deformed by heat during illumination , the

Adjustment of the printer

UV light
air-dried model can be completely placed in
water or glycerol.
❷ The illumination time can be adjusted
Recycled resin and tank cleaning
according to the intensity of the light , so
that the model can be completely cured.
❸ Excessive curing time will cause the
model to shrink and yellow , Insufficient
curing time will result in incomplete curing
Model
of the model. Cause the model to be too
soft.
42