Advertisement
Quick Links
This quick start guide provides first time setup instructions for the
For complete user instructions, please refer to the
epoc
®
Host Components
The figure below shows the
Status Indicators
Left - Wi-Fi & Bluetooth
Right - Battery
Barcode Scanner
button
(Silver, on side edge)
Cradle Blade
Epocal, Inc.
2060 Walkley Road
Ottawa, ON K1G 3P5
CANADA
epoc
Host Quick Start Guide
epoc
Host's primary components.
epoc
Barcode Scanner
Power button
Barcode Scanner
button
(Silver, on side edge)
Emergo Europe
Molenstraat 15
2513 BH, The Hague
The Netherlands
Phone: +31.70.345.8570
Fax: +31.70.346.7299
epoc
®
Host.
System Manual.
Stylus
51001684-05
Advertisement
Related Manuals for Epocal Epoc Host
Summary of Contents for Epocal Epoc Host
- Page 1 Barcode Scanner Barcode Scanner button button (Silver, on side edge) (Silver, on side edge) Cradle Blade Emergo Europe Epocal, Inc. Molenstraat 15 2060 Walkley Road 2513 BH, The Hague Ottawa, ON K1G 3P5 The Netherlands Phone: +31.70.345.8570 CANADA Fax: +31.70.346.7299...
- Page 2 Prior to use . . . epoc Step 1: Charge the Host epoc Before using the Host, charge its battery as follows: epoc 1. Connect the Reader power supply to the power jack on the back of the Reader. epoc 2.
- Page 3 • Tap to turn on the Wi-Fi radio and configure the Wireless network profile. • Tap 2. Configure Wi-Fi. NOTE: Screenshots are examples only. • Tap “New” . • Enter correct Network Name (SSID), then tap “Next” . • Select correct network security settings, then tap “Next”...
- Page 4 3. Confirm Wi-Fi connection. • Tap “OK” in the upper right hand corner to confirm a successful Wi-Fi connection. NOTE: The screen will display a successful Wi-Fi connection. epoc 4. Reset the Host. • Perform a soft reset by inserting the stylus in the hole on the bottom epoc side of the...
- Page 5 Host is now ready for use. epoc NOTE: Consult the System Manual for instructions on how to update the epoc Host software. NOTE: Before placing this unit into service, consult your facility’s internal quality control procedures and regulatory requirements.
- Page 6 Resetting the Host The Soft Reset button is recessed in the bottom of the epoc Host. To perform a Soft Reset, insert the stylus into the opening on the bottom of the Host Cradle. The Soft Reset Button may be used to restart the Host application if the epoc Host stops functioning and/or responding.
- Page 7 To remove the Version B cradle (plastic back, one piece): 1. Turn off epoc Host. 2. Undo two (2) Screws using correct Screwdriver so they remain captive in plastic housing. 3. Unclip Cradle from Barcode Scanner and lift Host up and out to remove from Cradle.
Need help?
Do you have a question about the Epoc Host and is the answer not in the manual?
Questions and answers