General - Sony TRINITRON KV-27S42 Service Manual

KV-27S42/27S46/27S66/29AL42/29AL42C/29AL66/
29AL66C/29SL42/29SL42C/29SL46/29XL42M
Connecting Your TV
This section covers basic connections in addition to any optional
equipment you may be connecting.
Basic Connections
TV with indoor or outdoor antenna, or CATV cable
Depending on the cable available in your home, choose one of the
connections below:
If you are connecting to an indoor or outdoor antenna, it will be necessary to
adjust the orientation of the antenna for best reception.
Cable and antenna
KV-27S66, 27V66 only
If your cable provider does not feature local channels, you may find this
set up convenient.
CATV cable
(No connection "TO
CONVERTER" in this case)
Antenna cable
Select CABLE or ANT mode by pressing
TV and Cable Box
1
Connect the coaxial cable from the wall to the IN jack on your cable
box.
2
Connect a coaxial cable (not supplied) from the OUT jack on your
cable box to the VHF/UHF IN jack on the TV.
To view channels from your cable box, tune your TV to channel 3 or 4 (as set
on the rear panel of your cable box).
If you will be controlling all channel selection through your cable box, you
should consider using the CHANNEL FIX feature on page 24.
SECTION 1

GENERAL

(Rear of TV)
AUX
TO CONVERTER
VHF/UHF
on the remote control.
3
Connecting Your TV
5
— 8 —
The following are partial abstracts from the Operating Instruction
Manual. The page numbers shown reflect those of the Operating
Instruction Manual.
User Guide
Connecting Additional Equipment
TV and VCR
2
VCR
1
From
Cable/
antenna
3 (Optional connection)
!
VCR must be connected and turned on to operate PIP. (KV-27S46 only)
1
Connect the coaxial cable from your TV antenna or cable TV to the IN
jack on your VCR.
2
Connect a coaxial cable (not supplied) from the OUT jack on your
VCR to the VHF/UHF IN jack on the TV.
To watch video programs from your VCR, tune your TV to channel 3 or 4 (as
set on the rear of your VCR).
(Optional connection)
3
If your VCR is equipped with video inputs, for better picture quality
you should connect A/V cables to AUDIO and VIDEO OUT on your
VCR to AUDIO/VIDEO IN on your TV. You can use the
to switch between the TV and VCR inputs.
For optimum picture quality, use S VIDEO instead of the yellow A/V cable.
S VIDEO does not provide sound, the audio cables must still be connected.
User Guide
TV, Cable box and Cable
KV-27S66, 27V66 only
For this set up, you can switch between scrambled channels (through
your cable box), and normal (CATV) channels by pressing
remote control.
When using PIP, the AUX input cannot be viewed in the window picture.
TV
button
4
on your
(Rear panel KV-27V66 only)
6