Maintenance And Storage - YTL -003-048 Instructions And Assembly

Improper maintenance and storage of the sweeper may void your warranty.
MAINTENANCE
After each use clean material out of hopper.
•
Rinse/dry inside and outside of the sweeper after each use.
•
Periodically check all fasteners for tightness and replace any damaged fasteners.
•
Check brushes for debris and keep brushes and brush shaft clean for optimal performance.
•
Twice a year apply a few drops of light multipurpose oil to the brush shaft bearings.
•
Annually clean and lightly lubricate all moving parts.
•
Every two years remove and clean gears and apply an even coat of light synthetic grease.
•
Use a glossy enamel spray paint to touch up scratched or worn painted metal surfaces.
•
Never exceed the hopper load capacity rating, as it will damage the bag.
•
Regularly grease axle and wheel bearing area or when needed.
•
LUBRICATION
The bearings in the sweeper have been pre-lubricated at the factory; however, it is recommended that
a few drops of light multipurpose oil should be added to the brush shaft bearings twice a year. Also,
every two years the wheels should be removed to clean the gears. After cleaning the gears, apply an
even coat of light synthetic grease.
NOTE: To remove wheel, use a screwdriver to pop off hub cap, remove the lock nut and washer.
WHEEL GEARS/PAWL SERVICE
DO NOT remove both wheels at the same time. Remove one wheel at a time to prevent mixing parts
or using the wrong parts as the left and right wheels and parts are different. When removing gears,
carefully note the position of all washers and other parts.

Maintenance and Storage

WARNING
- 16 -