Cleaning; Cleaning The Powder Hopper; Cleaning The Easyselect Manual Powder Gun - ITW Gema EASY 2-F Operating Instructions And Spare Parts List

CLEANING

Cleaning the powder hopper

NOTICE

Cleaning the EasySelect Manual powder gun

CAUTION
10
1. Disconnect the fluidizing air supply
2. Remove the injector
3. Remove the cover, blow out with compressed air and clean with a
clean dry brush and cloth
4. Clean the suction tube, and injector
5. Empty the remaining powder into a container
6. Vacuum the hopper and, above all, the floor of the hopper
7. Clean the hopper with a cloth
8. Reassemble the powder hopper
Refill the powder hopper shortly before reusing! Never clean the
powder hopper with solvents or water!
Frequent cleaning of the powder gun ensures the quality of the coating.
Switched off the control unit before cleaning the powder gun. The
compressed air used for cleaning must be free from oil and water.
Daily:
1. Blow off the exterior of the powder gun, and wiping clean etc.
Weekly:
2. Remove the powder hose from the connection.
3. Remove the nozzle from the powder gun and clean.
4. Remove the powder gun from the connection and blow through
with compressed air in the direction of flow.
5. Clean the powder gun tube with the spiral brush supplied.
6. Blow the powder gun through with compressed air again.
7. Clean the powder hose.
8. Assemble the powder gun and reconnect.
EASY 1-F / EASY 2-F