Advertisement
Quick Links
Advertisement
Related Manuals for ALRIGHT DEVICES Chronoblob2
Summary of Contents for ALRIGHT DEVICES Chronoblob2
- Page 1 ALRIGHT DEVICES CHRONOBLOB2 USER MANUAL VERSION 1.0...
-
Page 2: Table Of Contents
TABLE OF CONTENTS DESCRIPTION..............................3 SPECS................................. 4 QUICK REFERENCE............................5 USER INTERFACE............................6 SETTINGS................................11 FIRMWARE CHANGELOG........................... 11 SUPPORT................................11... -
Page 3: Description
DESCRIPTION Chronoblob2 is a digital delay module! Just like his little brother, Chronoblob2 can sync to a clock signal. Patch one into the SYNC input and choose a multiplier or divider for rhythmic delays. Or leave SYNC unpatched for access to continuously variable delay times! Chronoblob2 offers four different delay modes! Dual delay mode provides two separate delays with shared controls. -
Page 4: Specs
Choose tape mode for sweeping pitchbend effects, or fade mode for smoother, cleaner changes. Chronoblob2 offers an INFINITE LOOP button and gate input to shut off the delay inputs and lock the feedback at 100%. SPECS •... -
Page 5: Quick Reference
QUICK REFERENCE This reference card has been included with your Chronoblob2. If it becomes lost or damaged, you can print it again from this page. -
Page 6: User Interface
USER INTERFACE... - Page 7 A. FEEDBACK knob This knob sets the level of the feedback signal sent back to the delay input. The pink section of the arc indicates levels above 100%. The maximum is 125%. Where the black and pink sections of the arc meet, there is a small range where the feedback level snaps to exactly 100%.
- Page 8 press again to turn off), but you can change it to a momentary button (press to turn on, release to turn off) in settings (see the SETTINGS section). E. MODULATION MODE switch This switch selects the style of delay time modulation. In TAPE mode, a change in delay time creates a pitch-shift effect as though the read head is physically moving along the tape.
- Page 9 G. Status Indicators Each delay has a corresponding status LED, which blinks white at the delay rate and glows red when the input is overloaded (over 20Vpp). In DUAL and PING-PONG modes, they correspond to the left and right delays. In CASCADE mode, the left indicator corresponds to the outer delay;...
- Page 10 See (F) for details. L. SYNC input If a clock signal is present at this input, Chronoblob2 enters SYNC mode and the delay time will snap to multiplications/divisions of the clock according to the TIME controls. Chronoblob2 detects when something is connected to this input, so even if the clock stops, it will remain in SYNC mode until the patch cable is removed.
-
Page 11: Settings
SETTINGS You can access Chronoblob2's settings editor by holding the DELAY MODE button for a few seconds. The available settings are listed below. When you've finished, hold the DELAY MODE button again to save your settings and exit the editor.
Need help?
Do you have a question about the Chronoblob2 and is the answer not in the manual?
Questions and answers