Advertisement
Z E U S
QUICK-START GUIDE
A
Getting started
1
Cut straps
4
4
Open door by lifting up and back
7
Insert power cable in back, switch on
10
Wind excess back onto spool
Squeeze tabs with
thumb and index
13
Feed filament all the way down
Recommended: start with a test
16
Select a file
2
Remove all four plastic tabs
Remove
test printout
5
Remove interior packaging
8
Press front on button for 1 second
11
Press control button
14
Prep plate with thin layer of glue
17
Select print
3
Lift box + remove packaging
6
Place turnable 3 pins facing down
9
Unwrap filament and feed through tube
12
Press park button
15
Press print to access files
NB: "Box" test file print time:
> 8 mins
18
Lift glass plate then remove printout
Advertisement
Table of Contents
Summary of Contents for AIO ZEUS
-
Page 1: Getting Started
Z E U S QUICK-START GUIDE Getting started Lift box + remove packaging Remove all four plastic tabs Cut straps Remove test printout Open door by lifting up and back Remove interior packaging Place turnable 3 pins facing down Insert power cable in back, switch on Unwrap filament and feed through tube Press front on button for 1 second Wind excess back onto spool... - Page 2 When ZEUS is off line > 8 mins Wifi Ethernet For file transfer via wifi or ethernet, enter IP address (A or B) in computer browser to access Pydio. Login: aio Password: aiorobotics ZEUS UI - the basics Home Control...
Need help?
Do you have a question about the ZEUS and is the answer not in the manual?
Questions and answers