Table of Contents
Advertisement
Quick Links
Changing The Can-Am Spyder RT Windshield
Step 1:
Before shutting down engine, raise windshield to highest point.
Step 2:
Remove T-25 Torx bolts from back side of
windshield bracket. These are the fasteners that
hold the windshield trim pieces on. Place bolts on
seat with T-25 Torx tool.
Remove trim pieces by slightly pulling top of trim
out from windshield and moving trim piece
downward. This will release the trim piece from the
windshield. Lay on seat, left and right side noted.
TIP: Place a playing card (or something
similar) between the bottom point of the trim
piece and the windshield. This will prevent
the tip of the trim piece from gouging the
windshield when the trim piece is removed.
Step 3:
Remove T-30 Torx mounting bolts (a second set of
hands will be very useful) and remove windshield.
1 of 3
Advertisement
Table of Contents
Summary of Contents for F4Customs Can-Am Spyder RT
- Page 1 Changing The Can-Am Spyder RT Windshield Step 1: Before shutting down engine, raise windshield to highest point. Step 2: Remove T-25 Torx bolts from back side of windshield bracket. These are the fasteners that hold the windshield trim pieces on. Place bolts on seat with T-25 Torx tool.
- Page 2 Changing The Can-Am Spyder RT Windshield Step 4: Lay windshield on large flat surface. You will see metal spacers inside the rubber mounting grommets. Remove these by pushing out of grommet with a round object (a #3 Phillips screwdriver is perfect for the job). Carefully remove the rubber mounting grommets from the shield by slowly working them out of the holes in the shield.
- Page 3 Changing The Can-Am Spyder RT Windshield Step 7: Replace the trim pieces by placing L-shaped (don’t forget the playing card) tab into bottom square hole in shield. Use gentle pressure to push in toward windshield and UP so tab locks onto shield.
Need help?
Do you have a question about the Can-Am Spyder RT and is the answer not in the manual?
Questions and answers