Advertisement
1-2. TEMPORARILY
SETTING UP AND CONNECTING
CP-1 PWB ASSEMBLY
The following is an example of how to place and connect the main board without a jig, when repairing the CP-1 PWB assembly.
1.
Place the mechanism unit and main board up side down as
2.
Operete the unit using the buttons on TM-1 PWB or the
a whole on a flat surface with foil side of the main board
remote control.
facing up.
'i'+
L
'L
M-PK4HN/E-4
CP-1 PWB Assembly (Foil side)
\
Mechanism
Main Unit. \
(3
TM-I'PWB'
?+-./
/\
Cassette Cotipartment
yu
/--
rM-2
PWB
~
jr
Fig. 1-1-4
1-3. INSTALLATION
OF THE FRONT PANEL
When installing the front panel to the chassis after repaires and adjustments.
1.
Pressing down the door opener lever of the mechanism
Note:
Opened cassette door position does not install the front
main unit.
panel to the chassis.
2.
Set the cassette door to half-opened state as shown in Fig.
1-1-5, and install the front panel to the chassis.
M-PK4HNE-5
(Position A)
Cass&te
Door
(Position B)
Fig. 1-1-5
–7–
Advertisement
